36
General Care & Cleaning
Before cleaning any part of the oven, be sure all controls are turned OFF and the oven is COOL. REMOvE SPILLOvERS AND
HEAvY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL REDUCE THE EXTENT AND DIFFICULTY OF
MAJOR CLEANING LATER.
Surfaces
How to Clean
Aluminum (Trim Pieces)
& Vinyl
Use hot, soapy water and a cloth. Dry with a clean cloth. Do not scour or use all-purpose
cleaners, ammonia, powdered cleaners or commercial oven cleaner. They can scratch and
discolor aluminum.
Painted and Plastic Control
Panel, Body Parts, and
Decorative Trim
For general cleaning, use hot, soapy water and a cloth. For more difficult soils and built-up
grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes.
Rinse with a damp cloth and dry.
DO NOT
use abrasive cleaners on any of these materials;
they can scratch.
To remove control knobs, turn to the OFF position; grasp firmly and pull straight off the
shaft. To replace knobs after cleaning, line up the flat sides of both the knob and the shaft;
then push the knob into place.
Stainless Steel, Chrome
Control Panel, Decorative
Trim
Before cleaning the control panel, turn all controls to OFF and remove the control knobs. To
remove, pull each knob straight off the shaft. Clean using hot, soapy water and a dishcloth.
Rinse with clean water using a dishcloth. Be sure to squeeze excess water from the cloth
before wiping the panel; especially when wiping around the controls. Excess water in or
around the controls may cause damage to the appliance. To replace knobs after cleaning,
line up the flat sides of both the knob and the shaft; then push the knob into place.
Clean
stainless steel
with hot, soapy water and a dishcloth. Rinse with clean water and a
cloth.
Do not use cleaners with high concentrations of chlorides or chlorines.
Do not use
harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning
stainless steel. Always be sure to rinse the cleaners from the surface as bluish stains may
occur during heating that cannot be removed.
Porcelain Enamel Broiler
Pan and Insert (some
models), Door Liner, Body
Parts
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution
of clear water and ammonia. If necessary, cover difficult spots with an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and then scrub
with a soap-filled scouring pad. Rinse and wipe dry with a clean cloth. Remove all cleaners
or the porcelain may become damaged during future heating.
DO NOT
use spray oven
cleaners on the cooktop.
Oven Racks
Porcelain Coated Racks:
Some ovens come with lubricated porcelain oven racks, which can remain in the oven during
the self-clean cycle. Do not clean this vegetable oil lubrication off the racks. It is important
that the sides of the oven racks always have a light coating of vegetable oil. To maintain
optimal rack performance, re-apply a thin layer of vegetable oil to the sides of the rack
after every self-clean cycle or when the rack becomes difficult to slide.
Oven Door
DO
Hand
Clean Door
DO NOT
Hand Clean
Oven Door
Gasket
DO
Hand
Clean Frame
Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse well.
You may use a glass cleaner on the outside glass of the oven door.
DO NOT
immerse the
door in water.
DO NOT spray or allow water or the glass cleaner to enter the door vents.
DO NOT
clean the oven door gasket. The oven door gasket is made of a woven material,
on Self-Cleaning models, which is essential for a good seal. Care should be taken not to
rub, damage or remove this gasket.
Summary of Contents for Elite 790.9751 Series
Page 42: ...42 Notes ...
