Kenmore SSV Quick Clean 125.10440710, Use & Care Manual

- 11 -

LED Battery Indicator

This vacuum cleaner has two charging 

options.
It can be charged on the wall mountable 

charging dock while the unit is hung OR the
removable battery pack can be charged in
the detachable battery charger base.

Charging on Wall Mountable Charging Dock. 

The charger adapter output plug will fit into 

the battery charger base port only one way.
Insert the charging adapter plug into the 

port on the side of the charging base.

adapter is plugged in properly to the wall 

outlet and port on battery charger base. 

Also, ensure that the unit is properly seated 

in the charger dock with the pins contacting 

the charging plates of the vacuum head.
For better battery performance, always 

store the unit on the charging dock when it 

is not in use.

Charging on Battery Charger Base

Remove battery pack 
from hand vacuum by 
pressing the two 
release buttons on the 
sides of the battery 
pack while sliding backwards.

       WARNING

Before charging make sure unit is in the 

OFF position.

CHARGING

Plug the adapter into a wall outlet. 
Place the vacuum on the hook of the 

charging dock until the blue LED battery 

indicator starts to flash. 

Insert the battery pack along the slots on the 

charger base until you hear a click.
Ensure the charging adapter is plugged into 

a wall outlet. The blue LED will start blinking 

indicating the battery is charging.
The battery requires approximately 3.5 hours of 

charging to regain full capacity.
Once the LED indicator shows a continuous blue 

light, the battery is fully charged.
Detach the battery pack from the charger base 

by holding down the release button and sliding 

the battery outwards. Insert pack back into 

vacuum.

If inserted, remove 

battery charger 

base from the 

charging dock by 

pressing down on 

release button and 

sliding outwards.

The battery requires approximately 3.5 

hours of charging to regain full capacity.
While the unit is charging, the first bar of 

the battery indicator starts to flash. When 

the first bar is fully charged, the second 

one will start to flash while the first bar 

stays illuminated. The sequence continues 

repeating while the vacuum is charging.
When battery is fully charged, all four 

power level bars will flash 10 times, then 

turn off.

NOTE:

 If the LED does not illuminate 

when charging, ensure that the charging