Kenmore W10562379A, Installation Instructions Manual

7

It is your responsibility:

■

To contact a qualified electrical installer.

■

To be sure that the electrical connection is adequate and in 

conformance with Canadian Electrical Code, C22.1-latest 

edition and all local codes. A copy of above codes standard 

may be obtained from: Canadian Standards Association,  

178 Rexdale Blvd., Toronto, ON M9W 1R3 CANADA. 

■

To supply the required 4 wire, single phase, 120/240 volt,  

60 Hz, AC only electrical supply on a separate 30-amp circuit, 

fused on both sides of the line.  A time-delay fuse or circuit 

breaker is recommended. Connect to an individual branch 

circuit. 

■

This dryer is equipped with a CSA  

International Certified Power Cord  

intended to be plugged into a standard  

14-30R wall receptacle. The cord is  

5 ft. (1.52 m) long. Be sure wall receptacle  

is within reach of dryer’s final location.

If using a replacement power supply cord, it is recommended that 

you use Power Supply Cord Replacement Part Number 9831317.
For further information, please reference service numbers located 

in “Assistance or Service” section of your “Use and Care Guide.”

GROUNDING INSTRUCTIONS

SAVE THESE INSTRUCTIONS

■  

For a grounded, cord-connected dryer: 

This dryer must be grounded. In the event of malfunction or 
breakdown, grounding will reduce the risk of electric shock 
by providing a path of least resistance for electric current. 
This dryer is equipped with a cord having an equipment- 
grounding conductor and a grounding plug. The plug must 
be plugged into an appropriate outlet that is properly 
installed and grounded in accordance with all local codes 
and ordinances.

WARNING:

Improper connection of the equipment- 

grounding conductor can result in a risk of electric shock. 
Check with a qualified electrician or service representative 
or personnel if you are in doubt as to whether the dryer is 
properly grounded. Do not modify the plug provided with 
the dryer: if it will not fit the outlet, have a proper outlet 
installed by a qualified electrician.

Mobile home - Additional installation requirements: 

This dryer is suitable for mobile home installations. The installation 

must conform to the Manufactured Home Construction and Safety 

Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard 

for Mobile home construction and Safety, Title 24, HUD Part 280) 

or Standard CAN/CSA-Z240 MH.

Mobile home installations require: 

All dryers:

■

Metal exhaust system hardware, available for purchase  

from your dealer. For further information, see “Assistance  

or Service” section in your “Use and Care Guide.”

■

Special provisions must be made in mobile homes to introduce 

outside air into dryer. Openings (such as a nearby window) 

should be at least twice as large as dryer exhaust opening.

For gas dryers mobile home installations:

■

Mobile Home Installation Hold-down Kit Part Number 

W10432680 is available to order. For further information,  

see “Assistance or Service” section in your “Use and  

Care Guide.”

ELECTRIC DRYER POWER HOOKUP - 

CANADA ONLY

ELECTRICAL REQUIREMENTS

4-wire receptacle 

(14-30R)