6
7
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
Note: This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
causes harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS:
Modifications not expressly approved by Kensington may void the user’s authority to
operate the device under FCC regulations and must not be made.
SHIELDED CABLES:
In order to meet FCC requirements, all connections to equipment using a Kensington input
device should be made using only the shielded cables.
FCC DECLARATION OF CONFORMITY COMPLIANCE STATEMENT
This product complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) This device
may not cause harmful interference, and, (2) this device must accept any interference received, including
interference that may cause undesired operation. As defined in Section 2.909 of the FCC Rules, the
responsible party for this device is Kensington Computer Products Group, 333 Twin Dolphin Drive, Redwood
Shores, CA 94065, USA.
INDUSTRY CANADA CONFORMITY
This device has been tested and found to comply with the limits specified in RSS-210. Operation is subject to
the following two conditions: (1) This device may not cause interference, and (2) This device must accept any
interference, including interference that may cause undesired operation of the device.
This Class [B] digital apparatus complies with Canadian ICES-003.
CE DECLARATION OF CONFORMITY
Kensington declares that this product is in compliance with the essential requirements and other relevant
provisions of applicable EC directives.
For Europe, a copy of the Declaration of Conformity for this product may be obtained by clicking on the
Compliance Documentation
link at
www.support.kensington.com
.
THE FOLLOWING INFORMATION IS ONLY FOR EU-MEMBER STATES:
The use of the symbol indicates that this product may not be treated as household waste.
By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed information about recycling of this
product, please contact your local city office, your household waste disposal service or the shop where
you purchased the product.
Kensington and ACCO are registered trademarks of ACCO Brands. SlimBlade is a trademark of ACCO Brands. The
Kensington Promise is a service mark of ACCO Brands. Mac OS is a registered trademark of Apple, Inc. Windows
Vista and Windows are either trademarks or registered trademarks of Microsoft Corporation. All other
trademarks are the property of their respective owners.
© 2007 Kensington Computer Products Group, a division of ACCO Brands. Any unauthorized copying,
duplicating, or other reproduction of the contents hereof is prohibited without written consent from
Kensington Computer Products Group.
All rights reserved. 5/07
CLASS 1 LASER DEVICES (INVISIBLE LASER)
1. Emission of a parallel beam of infrared user-invisible light, which is safe under reasonably
foreseeable conditions of operation
2. Maximum power of 716 microwatts CW, wavelength range 832-865 nanometers
3. Class 1 laser beam is emitted from the bottom of the device
4.
CAUTION:
While the Class 1 laser in this product is safe under normal use, the laser beam
(which is invisible to the human eye) should not be pointed at anyone’s eyes.
CLASS 2 LASER DEVICES
1. Emission of a parallel beam of visible light
2. Maximum Power of 1 milliwatt CW, wavelength range 650±20 nanometers
3. Class 2 laser beam is emitted from the front of the device
4. Class 2 laser Safety Caution:
•
Do not stare into beam
•
Do not shine a laser pointer at anyone. Laser pointers are designed to illuminate inanimate objects
•
Do not allow minors to use a pointer unsupervised. Laser pointers are not toys
•
Do not point a laser pointer at a mirror-like (reflective) surface. A reflected beam can act like a direct beam
on the eye
•
Do not disassemble the device
•
Do not use the device outside of its specified operating temperature range
SAFETY AND USAGE GUIDELINES
1. In the absence of proper operation and if customer initiated troubleshooting is unsuccessful, switch off
device and call Kensington technical support.
www.kensington.com
.
2. Do not disassemble product or expose it to liquid, humidity, moisture or temperatures outside the
specified operating ranges of 0° C (32° F) to 40° C (104° F).
3. If your product is exposed to out of range temperatures, switch it off and allow temperature to return to
the normal operating range.
FIVE-YEAR LIMITED WARRANTY
KENSINGTON COMPUTER PRODUCTS GROUP ("KENSINGTON") warrants this product against defects in
material and workmanship under normal use and service for five years from the original date of purchase.
KENSINGTON, at its option, shall repair or replace the defective unit covered by this warranty. Please retain
the dated sales receipt as evidence of the date of purchase. You will need it for any warranty service. In order
to keep this limited warranty in effect, the product must have been handled and used as prescribed in the
instructions accompanying this warranty. This limited warranty does not cover any damage due to accident,
misuse, abuse or negligence. This limited warranty is valid only if the product is used with the equipment
specified on the product box. Please check product box for details or call KENSINGTON technical support.
DISCLAIMER OF WARRANTY
EXCEPT FOR THE LIMITED WARRANTY PROVIDED HEREIN, TO THE EXTENT PERMITTED BY LAW, KENSINGTON
DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ALL WARRANTIES OF MERCHANTABILITY
AND/OR FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT THAT ANY IMPLIED WARRANTIES MAY
NONETHELESS EXIST BY OPERATION OF LAW, ANY SUCH WARRANTIES ARE LIMITED TO FOUR YEARS. SOME
STATES/PROVINCES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE
ABOVE LIMITATIONS MAY NOT APPLY TO YOU.
LIMITATION OF LIABILITY
REPAIR OR REPLACEMENT OF THIS PRODUCT, AS PROVIDED HEREIN, IS YOUR EXCLUSIVE REMEDY. KENSINGTON
SHALL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING, BUT NOT
LIMITED TO, LOST REVENUES, LOST PROFITS, LOSS OF USE OF SOFTWARE, LOSS OR RECOVERY OF DATA, RENTAL
OF REPLACEMENT EQUIPMENT, DOWNTIME, DAMAGE TO PROPERTY, AND THIRD-PARTY CLAIMS, ARISING OUT
OF ANY THEORY OF RECOVERY, INCLUDING WARRANTY, CONTRACT, STATUTORY OR TORT. NOTWITHSTANDING
THE TERM OF ANY LIMITED WARRANTY OR ANY WARRANTY IMPLIED BY LAW, OR IN THE EVENT THAT ANY
LIMITED WARRANTY FAILS OF ITS ESSENTIAL PURPOSE, IN NO EVENT WILL KENSINGTON’S ENTIRE LIABILITY
EXCEED THE PURCHASE PRICE OF THIS PRODUCT. SOME STATES/COUNTIES DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER
RIGHTS THAT VARY FROM STATE TO STATE AND PROVINCE TO PROVINCE.
RF TECHNICAL SPECIFICATIONS
Operating Frequencies: 2.402 GHz~2.474GHz
