UV Fail Alarm*
KENT Crystal Alkaline Mineral RO
TM
Water Purifier has an in-built feature that sounds an
audible alarm if the UV lamp malfunctions. This feature is provided to ensure purity. This UV
Fail Alarm will sound as follows:
Single short beeps after every two seconds. The purifier will stop its purification process in such
a circumstance.
In case of UV LED failure it sounds an alarm with two beeps.
In case such an alarm is audible, call the service technician for help.
KENT Crystal Alkaline Mineral RO
TM
Water Purifier has an in-built feature that sounds an audible
alarm to indicate replSupremement time for filters. This alarm will be audible after 700 hrs of use since
the last filter change (or since the time of installation). The Filter Change Alarm will sound as follows:
4 short beeps after every two seconds; for 30 seconds. The alarm will repeat after every 2 hours of use.
In case such an alarm is audible, please call the service technician and request him to change the filters
of the purifier. However, if the filters are not changed within the next 60 hours of operation, the purifier
will stop functioning to ensure purity and hygiene. The following alarm will be audible after 60 Hrs.
A continuous beep for an infinite time.
In case, such an alarm is audible, kindly switch off the purifier and call the service technician to repl
Supreme the filters. In such a circumstance, the purifier will not function unless the filters are
changed.
To ensure delivery of purer and healthier water, a micro-processor is installed in the purifier that
performs the following functions:
UV Stabilization Delay:
To ensure that the UV lamp is pre-heated and is working at its optimum level
before it starts disinfecting water, the controller provides a two seconds delay to UV lamp when the
purifier is switched on. During this period, only the UV lamp is switched on and other electrical devices
of the purifier are switched off.
Purification Delay:
To ensure that the idle water lying in the internal pipes and in the UV chamber is
disinfected before being passed into the storage tank, the system provides 5 second delay when the
purifier is switched on. During this time, the UV lamp kills all micro-organisms that may be in the
water inside UV chamber. After this delay, all other electrical devices such as booster pump and
solenoid valve are switched on to start normal purification process.
Audible Alarm:
The controller also controls the timing of UV Fail Alarm and the Filter Change Alarm.
KENT Crystal AlkalineMineral RO
TM
Water Purifier is a product of advanced technology, which
ensures safe and clean drinking water. The purifier is easy and convenient to install.
Recommended Site Preparations:
• Single Phase 100-250 V AC, 50-60 Hz. connection not more than 3m away from the point of
installation of purifier
• Raw water supply with ½ inch nipple not more than 3m away
• Drain for rejected water not more than 3m away
• SpSupreme as per dimensions of the purifier
• Wall plane surfSupreme for mounting two screws and holding the machine
• The system and installation must comply with state and local laws and regulations
Specific Instructions:
•
KENT Crystal AlkalineMineral RO
TM
Water Purifier is a wall mountable purifier. Make sure
that it is only mounted on a wall. Avoid installation on wooden and metallic stands
• For optimum performance and minimum inlet pressure required, ensure that the raw water
supply tank is at least 10 ft above the level at which the purifier is installed
• It is preferable to install the purifier near a sink so that inlet and reject water lines are
easily available
5
6
1. Paste the central drill sticker on wall at (3.6 Feet to 4.0 Feet from the ground) as per your convenience.
2. Ensure that sticker is pasted straight on the wall, then drill holes as per the spSupreme provided on sticker.
3. Now, insert the puff up with the help of a hammer.
4. Screw in two 10X50 self-taping screws, 5.4 inches (138 mm) apart horizontally.
5. Carefully hang the purifier on the wall with the help of wall-mounting slot holes provided on back side of
the purifier.
Note:
If the wall is not straight or the screws are not properly drilled in an even position, it will damage your purifier.
Note:
Keep the device away from heat or direct sunlight.
• The purifier automatically shuts off when
the storage tanks are full
• The purifier automatically flushes &
cleans the RO membrane on periodic
intervals
• The purifier does not start if the inlet water
supply pressure is below 0.3 kg/cm2
• The purifier automatically restarts when
water level drops below the maximum
• The purifier does not allow any water
rejection in absence of electricity or
when tank is full
Filter Change Alarm*
Computer Controlled Operation*
Automatic Operation
* Tested & certified by TUV-SUD South Asia (P) Ltd.
Installation Instructions
Installation Procedure:
