Step-2
Figure 1.
Figure 2.
Figure 4.
Figure 3.
1
2
3
4
4
2
1
3
1. First fix the SS ball valve (marked as no. 4) to the 1/4 inch port of the 3-way connecter
(marked as no. 2) as shown in figure 2.
2. Connect the 3-way connector to the raw water supply (marked as no. 1) as shown in the
figure 3. The 3-way connector is fit in line with the raw water supply.
3. The other end of the 3-way connector can be connected to a tap (marked as no.3) as shown
in figure or can be plugged off if not required.
1. Now connect one end of the white pipe to SS ball valve and
another end to the upper push-fit elbow fitting to the left hand
side of the purifier labelled as WATER IN, as shown in fig 1.
2. Similarly, connect one end of the white pipe to the lower
elbow fitting connector in tank labelled as REJECT WATER
and leave the other end in the drain, as shown in fig 2.
Step-3
1. Connect the power supply.
2. Installation is complete.
Before connecting the power supply, it is important that you
perform the following functions:
1. Open the SS ball valve (Handle parallel to the ball valve)
to start the flow of water into the purifier, as shown in
the figure.
2. Wait for 2-3 minutes to ensure that the filters are soaked
in water.
Step-4
Step-5
Wall Hanging Diagram
Step-1
Slot holes
KENT ELEGANT LITE Mineral RO
TM
is a convenient and easy-to-install wall mounting model.
Recommended Site Preparations:
• Single Phase 100 – 250 V AC, 50-60 Hz not more than 3m away from the point
of installation.
• Raw water supply with ½ inch nipple not more than 3m away.
• Drain for the reject water not more than 3m away.
• Installation space as per the dimensions of the purifier.
• Wall/plane surface for mounting screws and holding the machine. Avoid installation
on wooden and metallic stands.
• For optimum inlet pressure the source water tank should be at least 10 ft. above the
purifier installed.
• Install the purifier near a sink for easy availability of inlet and reject water lines.
• The system and installation must comply with state and local laws and regulations.
1. Paste the central drill sticker on the wall at (3.6 feet to 4.0 feet from the ground) as per your
convenience.
2. Ensure that sticker is pasted straight on the wall, then drill holes as per the space provided on
the sticker.
3. Now, insert the puff up with the help of a hammer.
4. Screw in two 10X50 self-taping screws, 5.6 inches (142 mm) apart horizontally.
5. Carefully hang the purifier on the wall with the help of the wall-mounting slot holes provided on
the back of the purifier.
Note: If the wall is not straight or the screws are not properly drilled in an even position, it will
damage your purifier.
Note: Keep the device away from heat or direct sunlight.
• The purifier automatically shuts off when the
storage tank is full
• The purifier does not start if the inlet water
supply pressure falls below 0.3 kg/cm²
• The purifier automatically restarts when the
water level drops below the maximum
• The purifier does not allow any water
rejection in absence of electricity/when
tank is full
Automatic Operation
Installation Instructions
