KENT GEM WATER PURIFIER is a product of advanced technology, which ensures safe and
clean drinking water. The purifier is easy and convenient to install.
Recommended Site Preparations:
100-300V~, 50-60Hz single phase AC supply not more than 3m away from the point of installation
Raw water supply with ½" nipple not more than 3m away
Drain for reject water not more than 3m away
For optimum inlet pressure, source water tank should be at least 10ft above the
purifier installed
Install the purifier near a sink for easy availability of inlet and reject water lines
•
•
•
•
•
Automatic Operation
Installation Instructions
•
•
•
•
The purifier automatically shuts off when the
The purifier automatically restarts when
storage tank becomes full.
water level drops below the maximum.
The purifier does not start when inlet water
The purifier does not allow any water
supply pressure is below 0.3 kg/cm².
rejection in absence of electricity / when
tank is full.
4.
5.
6.
7.
Connect one end of blue pipe to elbow fitting connector labeled as
REJECT WATER and lead the other end to drain.
Turn on the lever given on SS ball valve to initiate the water flow to the purifier.
Allow the filters to pre-soak in water for 2-3 minutes.
Connect the power supply.
8.
Installation is complete.
Note:
• In case, you choose to place water purifier under the counter, install the faucet on the kitchen sink
or slab, connect one end of the white pipe to the faucet and the other end to the fitting connector
labeled as ‘Faucet’ on the back side of the purifier
• If the water purifier is placed as ‘Table Top’, never remove the dead plug from the connector
labeled as faucet
Use blue pipe for reject water
1.
2.
3.
Fasten the SS ball valve to the ¼ inch port of the 3-way connector.
Attach threaded end of 3-way connector to raw water supply and plug-off the
other end or connect to a tap.
Now connect one end of white pipe to SS ball valve and other end to
elbow fitting connector labeled as Raw Water, on the back side of purifier.
Use white pipe for raw water supply
TDS Adjustment
The unique TDS Control System enables customers to retain the contents of natural
minerals (TDS) in purified water, as per their requirement.
•
•
To increase the TDS level, turn screw of the
To decrease the TDS level, turn screw of
valve anticlockwise; resulting into increase
the valve clockwise; resulting into
in mineral content
decrease in mineral contents.
We recommend keeping the TDS at lowest but not below 50mg/l.
Starting Up the Purifier
•
•
•
•
•
•
Switch on the power supply
remove residual dust particles present in
the pipes and storage tank
Allow the storage tank to fill to the maximum
level
Switch on the power supply
Switch off the power supply
Purifier is ready to use
Open the Tap or Faucet present at the
Purifier and drain the tank as to
Installation Procedure :
5
6
NOTE: •
•
The glowing red LED indicates that the power is on
The glowing green LED indicates that the purification process is on
