Maintenance
To ensure that the purifier operates at its BEST, a routine maintenance must be
performed. The frequency of the maintenance will greatly depend upon the raw water
quality and consumption of purified water.
•
•
•
•
•
Storage tank must be drained once in 2
Replace RO membrane once in 2 years.
weeks. Open the tap or faucet present at the
Replace UF membrane once in 2 years.
Purifier and drain the tank and switch on the
power supply.
In the event of not using purifier for a long
time (while going for a holiday, tour etc.),
Replace sediment filter and activated carbon
make sure that you disconnect the power
filter once in 12 months. It is recommended
supply, turn off the raw water supply and
to change FRT along with the filters.
drain the storage tank.
Please note that the replacement time of consumables such as filters and
membrane is dependant on the quality of raw water and the quantity
of purified water consumed.
Use genuine Kent spares for optimum performance.
The reverse osmosis system contains a replaceable treatment component critical for the effective
reduction of total dissolved solids and that product water is tested periodically to verify that the
system is performing properly.
Replacement of spare parts are as under:-
-20010
SP Inline Sediment Filter 8”
-20009
SP Inline Carbon Block Filter 8”
-20002
SP RO Membrane Welded 8” Housing
-20004
SP UF Membrane Welded 8” Housing
-20018
SP FRT 550
Note: Filters and membrane are consumables. Their replacement time is dependent on the quality of raw
water and water consumption. They are not covered under the warranty. However, if a filter chokes
within six months and a membrane within a year, it will be cleaned/ repaired/ replaced free of cost.
Changing the filters and system inspection is available on call. The treatment capacity of RO membrane
will reduce with time due to clogging of pores of membranes.
“This reverse osmosis system contains a replaceable component critical to the efficiency of the system.
Replacement of the reverse osmosis component should be with one of identical specifications as
defined by the manufacturer, to ensure the same efficiency and contaminant reduction performance.”
Technical Specifications
TM
Product
:
KENT GEM Mineral RO WATER PURIFIER
Product Code
:
11029
Applications
:
Suitable for Purification of Brackish/Tap Water
Purification Capacity
:
Upto 15 LPH*
Body Material
:
ABS Engineering Plastic
Mounting
:
Counter Top / Under the Counter
Dimensions(mm)
:
440 (L) x 250 (W) x 400 (H)
Inlet Water Pressure/Temp (Min.)
:
0.3 kg/cm² or 4.267psi/10ºC
Inlet Water Pressure/Temp (Max.)
:
3.0 kg/cm² or 42.67psi/35ºC
Filter Cartridge
:
Sediment, Activated carbon
UF Filter
:
Ultra Filtration Membrane
Weight
:
11.500 kg
Storage Capacity
:
5 Litre
Membrane Type
:
Thin Film Composite RO
Max. Duty Cycle
:
75L/day
Booster Pump Voltage
:
24V DC
Power Consumption
:
60W
Mains Voltage
:
100-300V ~ ,50-60Hz 800mA
7
8
