35
M)
Use of the Optional Attachment
(1).Parallel Dressing Attachment
The wheel can be dressed either by diamond tool on the chuck or on the parallel
dressing attachment which is mounted on spindle carrier.
The diamond tool is arranged at an angle to the center line of the wheel as shown in the figure,
so that when the diamond tool is arranged at an angle, it ensures that there is always a sharp
diamond edge available.
The dressing method and points are the same as "Dressing the Wheel." Experience has shown
that, with highly accurate grinding, dressing with the diamond, which is mounted on a
magnetic chuck is better than that on the spindle carrier (the former is more stable than latter)
as the latter condition will cause slight undulation in the surface of the wheel.
(2).Brief Introduction to Attachment
a. Let the attachment be attracted to the magnetic chuck, keeping a 90° right angle
between the attachment and the wheel. The magnetic chuck should be kept leveled.
b
. The value in question will be the Sine of the angle times 50. That is B=Sin θX50
c. Get a block gauge the thickness of which equals that of B (or make one).
d. Put this Block gauge under the base of the Sine Bar stands.
Fix with the fastening bolts and the forming is done.
4 5
6
3
9
7
2
1
8
0°
～
45°
Property
of
Kent
Industrial
USA
Please
Do
Not
Reproduce
