R AD AR
9
1.5
Notice of work-piece loading
(1)
(2)
(4)
(5)
(7)
(6)
(3)
The work-piece loading should be carefully.
Be suggested to perform X, Z-axis origin-return action when clamp or remove the
work-piece to prevent tool damage caused by collision.
When clamp or remove work-piece, make sure the spindle is completely stopped.
When clamp the work-piece in the manual mode, the operator should rotate the
spindle to check the work-piece has been clamped tightly.
When clamp the special shape of work-piece, the operator should perform the
single-action mode to confirm whether the work-piece clamping or not, and make an
appropriate clamping fixtures, pay attention to their balance as well.
The heavy work-piece should be lifted by crane or hoist, to avoid the dangerous
electricity in a period, so even the amplifier power is turned off, it still has risk of
electric shock. It will take at least 20 minutes to make these disappear after power
off.
When replacing a new unit, should determine the new unit has the same parameters
and settings as the original one .Otherwise, it may result in unpredictable actions and
damage the work-piece and machine or harm the user.
As any failure of the machine happened and need repairing, please contact the
maker to avoid uncertainty factors occurred and cause an accident.
conditions happening.
Should be considered an appropriate workplace when perform lift or clamp work-piece.
The machine power and main power connected to electrical box must be shut down.
If operator turns machine power off only, the power may continue to supply the
operating area, it may cause an electric shock.
When perform a heavy work-piece replacing, should be performed by two or more
people.
After the power off, servo amplifiers and spindle amplifiers may also keep with
(8)
(9)
(10)
(11)
(12)
1.
Overall security
1.
Overall security
1.
Overall security
Property
of
Kent
Industrial
USA
Do
Not
Reproduce
