R AD AR
31
(3)
(4)
(5)
(6)
(7)
(2)
(1) Edit mode: Switch the selector to edit mode, the CNC controller can be
programming and modifying.
Auto mode: Switch the selector to automatic mode and press cycle start
button, can start machine and carry out the edited program to perform
the processing. To make sure the program and the safe and correct of
each axial position before starting the process program, avoids causing
damage to personnel and machinery.
Zero-return mode: Switch the selector to automatic mode, can let the X-axis
CNC controller parameter modifying etc., this mode to be used with
a single command, such as the M code start, G code to running,
the program start switch.
and Z axis return to mechanical origin by pressing the + X and + Z button,
can be used with rapid feed rate switch to change the speed ratio.
As zero returned, the panel lights will be lighting.
Jog mode: Switch the selector to jog mode, can make each shaft
moving depends on cutting feed speed, can be used with cutting feed rate
selector switch to adjust moving speed.
Handle mode: As in this mode, other modes are unable to perform, the axial
displacement only controlled by handle wheel. The displacement is 0.001,
0.01, 0.1 mm or 0.0001, 0.001, 0.01 inch for each cell.
Rapid feed mode: Switch the selector to rapid feeding mold to perform rapid
moving for each shaft. The moving speed can be adjusted by speed rate
selector (Figure 4.2).
Manual Data Input mode: Switch the selector to automatic mode, can run
EDIT
ZRN
HANDLE
JOG
RAPID
MDI
AUTO
Figure 4.1
HANDLE
RAPID
JOG
ZRN
MDI
AUTO
EDIT
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.2
Operation and trouble shooting
4.2.1 Mode selector switch
Property
of
Kent
Industrial
USA
Do
Not
Reproduce
