R AD AR
48
4.7 Correction mode of tool magazine
Tool magazine zero-return correcting steps: Before starting tool magazine correction
mode, you must remove the tool from Z-axis first.
Turn on the Keep relay 3.0 (K3.0 = 1), then the X and Z axes will be interlocked,
screen will display the angle of current location of B-axis(It means tool holder as well),
the program of " Tool magazine correction mode" , the start and pause button light
will start flashing.
Choose HANDLE mode and the door of Tool magazine is opened.
(1)
(2)
Then press CW or CCW. Press one time is start, and press two times is stop.
Then it can control CW or CCW.
If want to move the X or Z axis, should close Keep relay 3.0 (K3.0 = 0) first then
perform it. To set axial- direction selector in the X or Z axis, then turn MPG in a
(3)
clockwise or counter-clockwise, so that can control the X or Z axis to move to "+"
direction or "-" direction.
Do not hold down the "Tool fix / loose key , can perform X or Z axis moving operation.
(4) Set parameter no. 11 #0 as 1. Turn off the power, then restart machine. It should be
set already. ( PMM type )
OFF
X
Z
C
E
B
Y
×
100
×
10
×
1
Figure 4.29
4.
Operating
4.6
Property
of
Kent
Industrial
USA
Do
Not
Reproduce
