R AD AR
63
Enter zero point parameter to set the zero point.
(6)
This position has one difference pocket with actual pocket no.1 position.
(7)
Turn on the power and turn to pocket no. 1. Then do the zero point setting
(8)
again. This setting is benchmark.
(1815 #4 SET 1 / NO0011 #0 SET 1)
To check the sensor at the back side, to see if the light is off. (Normal is off.)
(9)
If the light on, the angle is not correct. Should turn the angle of carousel till
(10)
the light off position.
Clamp tool on the spindle. Move X and Z axis into ATC.
(11)
Use manual mode to move the tool into pocket.
(12)
Unclamp tool, then clamp tool again.
(13)
If carousel has obviously shaking, adjust X/Z axis to the best position, no
(14)
obviously shaking position. This is tool changing point.
Memorize machinery coordinate.
(15)
Unclamp tool, and move Z-axis positively 12mm. This machinery
(16)
coordinate is Z-axis tool changing point.�Enter this machinery coordinate
into parameter P1241 and compare with Z-axis position, then modify the
error.
Figure 5.21
5.
Adjustment
5.
Adjustment
5.
Adjustment
5.
Adjustment
5.
Adjustment
5.
Adjustment
5.
Adjustment
5.
Adjustment
5.
Adjustment
5.
Adjustment
5.
Adjustment
Property
of
Kent
Industrial
USA
Do
Not
Reproduce
