R AD AR
75
a.
b.
c.
a.
b.
c.
d.
e.
f.
g.
Precautions while operating the machine:
During operation, if there are any unexpected accidents happened, to stop the
machine immediately by pressing the emergency stop button.
As input tool compensation value, check the the positive and negative sign and
decimal point of X-axis and Z axis, to avoid the wrong moves and hit the tool.
If cutting operation is interrupted, should press the right button on panel, and
restart the program.
Check the work-piece is clamped securely, and whether it may be causing the
work-piece fly-out because the spindle chuck and claw loosing,
(note the proper clamping pressure and fixtures).
Check the tool clamped tightly.
Make sure the program is correct, especially the plus or minus sign and decimal
point of X-axis and Z axis before running.
Correctly set the reference position of the work-piece.
Enter the correct tool Compensation value.
After cutting test, if necessary, measure the work piece and updates the program
and compensation values.
Confirm the program executed from the correct start position.
Other notices:
Panel should be kept clean.
Filters should be cleaned regularly
After starting the machine, not run machine in high-speed immediately, the machine
should be gradually increased speed from the low speed after pre-heating.
When the iron filings deposited to a certain amount, starts the car to discharge iron
filings. Avoid iron filings overflow affecting the normal operation.
If want to turn off the machine, press emergency stop switch down first, then turn
off the power.
In order to avoid tool collision, please follow the instructions:
a.
b.
c.
d.
e.
(4)
(5)
(6)
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
Property
of
Kent
Industrial
USA
Do
Not
Reproduce
