R AD AR
82
6.3.5
Irregular
anomaly
Reason
Periodic
cycle time is
not right
Lubricants
rate
Insufficient
Pressure
does not rise
Oil does not
flow out
(1) Pipe joints leaking.
(2) Oil filter blocked
(3) Oil viscosity is too high
(4) Oil deterioration or oxidation
(5) Air sucked from suction pipe
(6) Pump wearing cause
sucking ability reduced
(1) Oil shortage
(2) Motor is not working properly
(3) Voltage does not match
(4) Motor damage.
(5) Two connecting pipe loosing.
Periodic cycle time setting error
(7) Distributor's transfer rate is
not correct
Modify cycle time by the parameters
Re-tighten the tubing connector
Replace or clean filter
Increase the oil temperature (heat engine)
Replace the lower viscosity lubricant
Clean up oil tank, replace oil
Release the inhaled air; check the oil
Repair or replace the wearing parts.
Modify the transfer rate, If necessary,
Re-fixed, lock or replacement.
Check the pressure gauge, if necessary;
If valve or base worn or damaged,
Remove dust.
Re-injection of the same brand of oil.
Replace the motor.
Re-tighten the connecting pipe.
volume and tubing connectors.
If necessary, re-tighten the connector.
replace the distributor.
(1) Pipe joints around the region
(2) Control valve not operating
(3) Pressure settings are not
(4) no good contact between
(5) Dust adsorbed firmly
leaking
properly.
appropriate.
base and valve
correct the pressure by standard setting.
it should be repaired, or re-assembly.
Correct supply voltage.
Maintenance and countermeasures
Countermeasures
6.
Maintenance
6.
Maintenance
6.
Maintenance
6.
Maintenance
Property
of
Kent
Industrial
USA
Do
Not
Reproduce
