8
7
Before connecting the power supply, it is important that you perform the
following functions:
1.
Open the SS ball valve (Handle parallel to the ball valve) to start the flow
of water into the purifier, as shown in the figure.
2.
Wait for 2-3 minutes to ensure that the filters are soaked in water.
1.
Now connect one end of the white pipe to SS ball valve and another end
to the upper push-fit elbow fitting to the left hand side of the purifier
labelled as WATER IN, as shown in fig 1.
2.
Similarly, connect one end of the white pipe to the lower elbow fitting
connector in tank labelled as REJECT WATER and leave the other end
in the drain, as shown in fig 2.
Step-3
Step-4
Connect the power supply.
Step-5
Installation is complete.
Although the rejected water has high concentration of
We recommend KENT RO Reject Water Storage
salts, it is absolutely clean and free from impurities like
Tank can be purchased separately to store & use
chlorine, dirt, sand, etc. This rejected water usually
RO reject water.
goes down the drain but can be used for cleaning
utensils & mopping the floor .
Recommended Uses of Rejected Water
Warning: The water stored in RO Reject Water Storage Tank is not fit for drinking.
Step 06:
Screw the lid properly.
Step 06:
The storage tank is ready for installation.
B. Wall hanging procedure
Step 01:
Paste the center drill sticker on the
wall preferably at 3.6 to 4 feet from
the ground or as per convenience.
Step 02:
Ensure that the sticker is pasted
straight on the wall. Drill holes as per
the markings provided on the sticker.
Step 03:
Using a hammer, insert the puff-up in
the wall.
Step 04:
Screw two, ‘10 x 50’ sized self-taping
screws, 5.5 inches (140 mm) apart
horizontally.
Step 05:
Install the tank on wall using screws.
Step 06:
Connect the pipes as shown in the
image. Connect 1/4" reject water pipe
from the RO to the smaller fitting and
3/8" pipe to the bigger fitting and put
the open end into the drain.
Installation is complete.
Note:
1. Keep the tank away from direct sunlight or heat.
2. If mounted on uneven wall surface or the screws are not properly drilled, it could damage the tank.
RO Reject
Water Storage
Tank
Over flow pipe
to drain
RO Water
Tank
RO Reject Water Storage Tank (Optional Purchase)
The Ideal place for installation is above the sink as rejected water is ideally used for cleaning, utensils or
mopping the floor. Every house has used utensils, which can be cleaned first with rejected water &
subsequently with clean water. If you still have extra water left, we recommend you to use for mopping/
cleaning the floor.
Installation Instructions
A. Assembly of tank
Step 01:
Open the box and take the storage tank out.
Step 02:
Unscrew and remove the top cover.
Step 03:
Using silicon washer, fix the tap on to the tank.
Step 04:
Attach the fittings on to the holes provided on
the side of the tank.
Step 05:
Place the lid back and make sure it is
placed properly.
