Installation Procedure :
Screw in the two 10x50 self taping screws (supplied with the package) on a same horizontal level at
a distance of 5.4 inches (138 mm) from each other in the wall.
Carefully hang the purifier on the wall with the help of wall mounting slot
holes present on the back side of the purifier as shown in the figure below.
Fix the SS ball valve to the ¼ inch port of the 3-way connector as shown in the figure.
1.
2.
3.
4.
Connect the 3-way connector to the raw water supply as shown in the
figure. The threaded end of the 3-way connector is fitted in line with the
raw water supply. The other end can be connected to a tap or can be
plugged off if not required.
TM
The
Prime
TC
Mineral RO
Water Purifier is a product of advanced technology, which ensures safe
and clean drinking water. The purifier is easy and convenient to install.
Recommended Site Preparations :
100-300 V~, 50-60Hz single phase AC connection not more than 3m away from the point of installation
of purifier
Raw water supply with ½” nipple not more than 3m away
Drain for rejected water not more than 3m away
Space as per dimensions of the purifier
Wall/plane surface for mounting two screws and holding the machine
The system and installation must comply with state and local laws and regulations
Specific Instructions :
TM
Prime TC
Mineral RO Water Purifier is a wall mountable purifier. Make sure that it is only
mounted on a wall. Avoid installation on wooden and metallic stands
For optimum performance and minimum inlet pressure required, ensure that the raw water supply
tank is at least 10 ft above the level at which the purifier is installed
It is preferable to install the purifier near a sink so that inlet and reject water lines are easily
available
KENT
KENT
n
n
n
n
n
n
n
n
n
Installation Instructions
6
Slot holes
5
UV Fail Alarm
To ensure delivery of 100% pure and healthy water, a micro-processor is installed in the purifier that
performs the following functions: -
UV Stabilization Delay: To ensure that the UV lamp is pre-heated and is working at its optimum level
before it starts disinfecting water, the controller provides a two seconds delay to UV lamp when the
purifier is switched on. During this period, only the UV lamp is switched on and other electrical
devices of the purifier are switched off.
Purification Delay: To ensure that the idle water lying in the internal pipes and in the UV chamber is
disinfected before being passed into the storage tank, the system provides 5 second delay when the
purifier is switched on. During this time, the UV lamp kills all micro-organisms that may be in the water
inside UV chamber. After this delay, all other electrical devices such as booster pump and solenoid
valve are switched on to start normal purification process.
Audible Alarm: The controller also controls the timing of UV Fail Alarm and the Filter Change Alarm.
Computer Controlled Operation
n
n
n
n
The purifier automatically shuts off when the
The purifier automatically restarts when
storage tank becomes full
water level drops below the maximum
The purifier does not start when inlet water
The purifier does not allow any water rejection in
2
supply pressure is below 0.3 kg/cm
absence of electricity / when tank is full
Automatic Operation
KENT
TM
Prime
TC Mineral RO Water Purifier has an in-built feature that sounds an audible alarm if the UV
lamp malfunctions. This feature is provided to ensure 100% purity. This UV Fail Alarm will sound
like following:
Two short beeps after every two seconds.
In case such an alarm is audible, kindly switch off the purifier and call the service technician for help. The
purifier will stop its purification process in such a circumstance.
2 Sec.
2 Sec.
2 Sec.
2 Sec.
Filter Change Alarm
KENT
Prime TC Mineral RO has an in-built feature that sounds an audible alarm to indicate replacement
time for filters. This alarm will be audible after 700 hrs of use since the last filter change (or since the time
of installation). The Filter Change Alarm will sound like following:
4 short beeps after every two seconds; for 30 seconds. The alarm will repeat after every 2 hours of use.
In case such an alarm is audible, please call the service technician and request him to change the filters of
the purifier. However, if the filters are not changed within the next 60 hours of operation, the purifier will
stop functioning to ensure purity and hygiene. The following alarm will be audible after 60 Hrs.
A continuous beep for an infinite time.
In case, such an alarm is audible, kindly switch off the purifier and call the service technician to replace
the filters. In such a circumstance, the purifier will not function unless the filters are changed.
2 Hours
30 Sec.
30 Sec.
