3
UNPACKING AND SET UP
Carefully inspect all components to insure that there is
no concealed freight damage. If such damage is dis-
covered, file a Damage Report immediately with the de-
livering carrier.
Install the batteries and cables as illustrated on the
BATTERY WIRING DIAGRAM located inside the ma-
chine on the hood.
PREPARATION
WARNING: BEFORE ANY SERVICING BE SURE
THE MACHINE IS TURNED OFF AND THE BAT-
TERY CHARGER IS DISCONNECTED.
PAD INSTALLATION (Figure 1)
CAUTION: Use of burnishing pads larger than 19”
diameter will damage this machine.
Turn the MASTER SWITCH “ON” and raise the pad
head by toggling the PAD LIFT SWITCH to the “UP” po-
sition. Open the machine’s hood and tilt the pad head
back. Unscrew the padholder, center the pad on the
driver and press on. Replace the padholder.
CONTROLS
MASTER SWITCH (Figure 2)
Turn on main power for machine operation. When this
switch is in the “ON” position, the pilot light is illumi-
nated.
VACUUM MOTOR SWITCH (Figure 3)
Turn on the vacuum motor to collect dust created when
burnishing the floor.
PAD LIFT SWITCH (Figure 4)
Toggle to OFF to raise or ON to lower the pad head.
PAD PRESSURE GAUGE (Figure 5)
This reference gauge shows the amount of pad pres-
sure on the floor relative to the amount of amperage
draw on the pad drive motor.
PAD PRESSURE ADJUSTMENT KNOB (Figure 6)
Turn knob counterclockwise to increase “+”, clockwise
to decrease “-” pad pressure.
TRAVERSE SPEED (Figure 7)
Turn knob counterclockwise to increase machine
speed, clockwise to decrease.
CIRCUIT BREAKER - 70 AMP (Figure 8)
This protects the pad drive motor circuit from overloads.
CIRCUIT BREAKER - 5 AMP (Figure 9)
This protects the dynamic braking system from a po-
tential short circuit.
SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING!
When using an electrical appliance, basic precautions
should always be followed, including the following:
WARNING
Failure to follow these safety instructions could
result in damage to the machine, damage to prop-
erty, or bodily injury.
fl Use machine only as described in this manual.
Do not use in ways it was not intended. Use only
manufacturer's recommended attachments.
fl Do not leave the machine unattended when it is
turned on. Turn off all switches when not in use
and before servicing.
fl Do not allow to be used by untrained personnel.
Close attention is necessary when used near
children.
fl If the machine is not working as it should, has
been dropped, damaged, or left outdoors, return
it to a service center before using.
fl Be cautious when working with batteries. Always
wear protective eye and clothing items.
fl Avoid electrical shock, remove all jewelry and do
not place tools or other metal objects on or near
the batteries.
ˇ Do not use a charger with a damaged power
cord.
fl This machine creates suction and contains a
rotating pad. Keep hair, loose clothing, fingers,
and all other parts of the body away from open-
ings and moving parts. Do not insert any object
into any of the openings in the machine.
fl Do not pick up anything that is burning or smok-
ing, such as cigarettes, matches, or hot ashes.
fl Do not use the machine to pick up flammable or
combustible liquids such as gasoline. Do not use
in areas where flammable and/or explosive vapor
or dust is present.
fl Do not use on a floor with damaged or loose tiles.
ˇ Do not transport the machine without securing it
to the bed of the vehicle.
SAVE THESE INSTRUCTIONS
https://harrissupplyind.com - To Order Parts Call 608-268-8080
