5
PRODUCT IDENTIFICATION
If service is required, contact the dealer from which
the machine was purchased or an authorized service
station. The model and serial number are on the rating
plate, please write them in below. For prompt and accu-
rate information, refer to these numbers when inquiring
about service. Always refer to your limited warranty for
complete service information.
MODEL#
SERIAL#
OPTIONAL ACCESSORIES
For a complete list of all available accessories and or-
dering information, contact your local equipment dealer
or the dealer from which the machine was purchased.
SOLUTION
1. Check batteries and charge or replace.
2. Adjust speed control knob as needed.
1. Check batteries and charge or replace.
2. Reset by pushing circuit breaker button.
3. Adjust pad pressure knob accordingly.
4. Move control handles to either forward or
reverse position.
1. Raise the pad head and clean the pad.
2. Replace the pad.
1. Recharge batteries fully before beginning
operation.
2. Clean thoroughly.
3. Replace defective battery.
1. Check pad and replace if worn or
damaged.
2. Reinstall pad, make sure it is centered on
the padholder.
1. Reset by pushing circuit breaker button.
2. Reduce pad pressure using adjustment
knob.
3. Raise the pad head and clean the pad.
4. Contact the dealer from which the
machine was purchased, or an autho-
rized service center.
1. Contact the dealer from which the
machine was purchased, or an autho-
rized service center.
CAUSE
1. Battery condition low.
2. Speed set too low.
1. Battery condition low.
2. Circuit breaker tripped.
3. Pad pressure adjustment knob set to
highest or lowest setting possible.
4. Control handles not in operating position.
1. Debris lodged under pad.
2. Worn pad.
1. Battery charge condition very low.
2. Corroded wires or connectors.
3. Bad Battery.
1. Pad worn or damaged.
2. Pad not installed correctly.
1. Momentary motor overload.
2. Too much pad pressure.
3. Possible lodged debris.
4. Damaged motor.
1. Short circuit in dynamic braking circuit.
PROBLEM
Machine will not move
Pad drive motor will not start
Machine streaking a cleaned floor
Short operating time
High vibration
70 AMP breaker trips or trips repeatedly
5 AMP breaker trips
TROUBLE SHOOTING GUIDE
https://harrissupplyind.com - To Order Parts Call 608-268-8080
