Alarm repeat
Set the time, when a triggered alarm shall be triggered.
The alarm will be sent to the entered e-mail-addresses until all values are in normal range again.
A value of 0 sets the alarm repeating to inactive
Alarm buzzer time
Time in seconds how long the internal buzzer will sound after an alarm.
Alarm relay time
Time in seconds, how long the open collector output is set when an alarm is triggered.
Motion detection - Arm-Disarm time
Switching time for the time-controlled arming and disarming from the integrated motion detection.
To use it, a time server (NTP) must be set in the network settings.
6.6.4. Users
User accounts
You can set up to 5 user accounts with individual passwords. With the first user it is also possible to access the
integrated FTP server. For the e-mail alerting, enter the addresses of the recipients.
6.6.5.
Konfiguration
Device name
Configuration of the device name, this is freely selectable
Language
Select the display language of the website of the Kentix MultiSensor-LAN.
You can select between German and English language.
Temperature unit
Changes the temperature evaluation and display of the MultiSensor-LAN between Celsius and Fahrenheit.
Communication key
The communication key is used for data encryption when operating with an AlarmManager.
This must also be stored in the AlarmManager.
NTP1/2
Configuring the Time Server (Network Time Protocol). The NTP configuration is required for timed arming and
data logging.
Public NTP Server: 0.de.pool.ntp.org or 1.de.pool.ntp.org
IP Address / Netmask / Gateway / DHCP / MAC Address
Network configuration of the MultiSensor. You can enable DHCP for IP configuration, in which case the
MultiSensor must always be assigned the same IP address from the DHCP server. The MAC address of the
device can be read here. This is required for router or firewall settings.
DNS 1/2 (Domain Name Server Addresses)
Depending on the network configuration, e.g. if using an ADSL router, this may also be the gateway address.
Public DNS Server: 8.8.8.8 or 8.8.8.4
Changes on network settings are active direct after saving the configuration.
Page
(07-2018, subject to change)
kentix.com
32
Mu
lti
Se
n
so
rs
Sm
a
rt
Mo
n
ito
ri
n
g
