AlarmManager communication
Enable communication with a Kentix AlarmManager PRO. Enter the IP address of the AlarmManager and
activate the communication by ticking the box.
If the MultiSensor should be able to send e-mails in the case of alarm to a configured user, it is necessary to set
an e-mail server (SMTP or ESMTP). When you have set a DNS server, which is configured in the DNS settings,
you can use the DNS name of the e-mail server here. With using ESMTP you can here enter the e-mail access
data, which you can obtain from your e-mail provider. Depending on the E-mail server, a encryption method
might be necessary. When choosing an encryption mode (STARTTLS / SSL) the required port will be set to the
default port. The port can be changed to another one when needed.
Pay attention that many mail servers need an existing sender address to send an e-mail correctly.
In the subject of the e-mail the corresponding alarm text can be found and in the mail text all measurements
from the MultiSensor are included.
E-Mail Signature
Enter a signature, which is sent with every alarm E-Mail. The signature is limited to 300 signs length.
SNMP settings
Configuration of the Simple Network Management Protocols. The MultiSensor-LAN is able to send alarm
messages as SNMP-Traps. Enter
both
SNMP host addresses for this. Further the sensor can be prompted or
partially configured via SNMP. The functions which are available for the SNMP communication are specified in
the supplied MIB (Management Information Base). It is available on the integrated FTP server or as download
from the Kentix website.
Network camera
In the event of an alarm, the MultiSensor LAN can retrieve image data from a network camera and save it to an
SD card. The image data is then linked to the logbook entry of the alarm. For this purpose, any network camera
can be used, where it is possible to pick up pictures via an HTTP command.
Enter a name for the camera (such as installation location), as well as the camera-specific data such as IP
address and user data, and select the location of the camera.
The field "HTTP command" contains an example of an AXIS camera. Enter the path to the image source file
without specifying the IP address or communication port starting with a slash.
The AlarmManager-PRO takes over the configuration of the alarm settings of the MultiSensor, the
local alarm / threshold values are then inactive.
Page
(07-2018, subject to change)
kentix.com
33
Mu
lti
Se
n
so
rs
Sm
a
rt
Mo
n
ito
ri
n
g
