9.6.2.13. Configuration - Network
This are the network settings of the AccessPoint. The device is delivered with a default configuration.
Default IP-address:
192.168.100.224
Subnet-mask:
255.255.255.0
Username / password: admin / password
This data can be altered for an operation in the own environment after commissioning.
IPv4-address, subnet mask, gateway
Network configuration of the AccessPoints. DHCP can be optionally activated. In this case always the same IP-
address has to be assigned to the AccessPoint. For this the MAC-address is displayed here.
Alternatively manual network settings can be entered.
DNS server address 1 / 2 (Domain Name Server Addresses)
Depending on the network configuration (e.g. in combination with a DSL router) this can also be the gateway
address.
Public DNS Servers: 8.8.8.8 or 8.8.8.4
9.6.2.14. Configuration - Communication
E-Mail Data
To send e-mails to the configured users (e.g. to warn about a low battery level), an e-mail server
(SMTP or ESMTP) has to be configured in the AccessPoint.
When a valid DNS server if configured, the DNS name of the E-Mail server can be used. With ESMTP it is also
possible to work with public e-mail servers which require a user authentication. Also the selection of an
encryption method (STARTTLS / SSL) is possible. The communication port can be changed, if necessary.
Please note, that often e-mail servers also require a valid sender address to forward e-mails.
E-Mail signature
Enter a signature, which will be appended to each e-mail. The signature is limited to a length of 1000 signs.
SNMP Settings
The AccessPoint supports SNMP V2 to call up the access log.
For this a MIB (Management Information Base) is available.
Alarms can also be sent in the form of SNMP traps to up to 2 hosts. To do this, enter the destination IP
addresses for the hosts and the corresponding communication port (default: 162).
For call ups, a name must additionally be entered in the field "Public Community".
AlarmManager-Communication
Here the AlarmManager-Communication for a remote arm-/disarm-switching of a Kentix alarm system is
configured.
Enter the IP-address of your AlarmManager and an AlarmManager-user and password.
This user must exist in the configuration of the AlarmManagers and have the authorization „Administrator“.
In the AlarmManager also the communication key of the AccessPoint must be configured.
The changes in the network settings are directly active after saving.
Page
(07-2018, subject to change)
kentix.com
85
Sm
a
rt
A
c
c
e
s
s
