Ext. alarm output
Label for the switching output (output 2). With this output external devices or signals can be switched. It is
controlled via SNMP. Pay attention to the electrical connection conditions in the manuals.
Alarm buzzer time
Time in seconds how long the internal buzzer will sound after an alarm.
Alarm relay time
Time in seconds, how long the open collector output is set when an alarm is triggered. You can trigger with
this output e.g. relays. Pay attention to the electrical connection conditions in the manuals.
Re-arming time
Set the time, when the sensor motion detection has to rearm, after a motion alarm is triggered.
The red alarm LED will be turned off after that time.
Alarm repeat
Set the time, when a triggered alarm shall be triggered.
The alarm will be sent to the entered e-mail-addresses until all values are in normal range again.
A value of 0 sets the alarm repeating to inactive.
User accounts
You can set up to 5 user accounts with individual passwords. The passwords also allow access to the FTP
server. For the e-mail alerting, enter the addresses of the recipients.
User accounts and notification
User accounts
You can set up o 5 user accounts with individual passwords. The passwords allows also to access to the
FTP server. For the e-mail alerting, write down the addresses from the receivers.
E-mail signature
Enter a signature for e-mail notifications. This signature has a limit of 300 characters.
Language
Choose the language of the Website from the Kentix MultiSensor-LAN. It is possible to choose between the
english and the german language.
Page 8
!
(09-2012, subject to change)
!
www.kentix.de
