5
Ford 6.0 Liter Engine
1.
Remove EGR valve (2 bolts). Install DFS 910-1, turn valve to Intake position and
attach DFS 910-5 to DFS 910-1. Attach Blue and Black Hose (valve side) to
DFS 910-5 close valve on DFS 910-5.
2.
Set air Pressure on Atomizer Tank to 80 psi. Start Engine
3.
On the machine turn Atomizer valve to ON position and open Air valve on
DFS 910-5.
4.
After 1 lit/qt turn valve to Exhaust position on adapter DFS 910-1 run until Atomizer
fluid tank is empty.
5.
Turn Atomizer valve of and Fill the Atomizer Tank with 1 lit/qt Rinse Solution and
repeat the above steps.
6.
When finished turn Atomizer Valve to OFF position. Turn Vehicle off, turn fuel
pump off disconnect fuel hoses, adapters and reattach the EGR valve and fuel lines.
Ford 6.4 Liter Engine
1.
Remove Temperature sensor on the EGR cooler. (Clean it with the Induction cleaner).
Install adapter DFS 910-2 to the EGR cooler.
2.
On the vehicle remove Induction tube then place the DFS 910-3 S-Hook nozzle in the
induction tube and attach Blue hose to DFS 910-3 S-Hook Sprayer.
3.
Set air Pressure on Atomizer Tank to 80 psi.
4.
Start Engine
5.
On the machine turn Atomizer valve to ON position.
6.
After 1 lit/qt turn Atomizer valve to OFF position on the machine and remove DFS
910-3 S-Hook from vehicle induction tube and remove Blue hose from S-Hook
Spayer.
7.
Attach Blue and Black hoses to DFS 910-5 adapter and attach DFS 910-5 to
DFS 910-2.
8.
Open Air valve on DFS 910-5 adapter then turn the Atomizer valve to ON position on
the machine, run until Atomizer fluid tank is empty.
9.
Turn Atomizer valve of and Fill the Atomizer Tank with 1 lit/qt Rinse Solution and
repeat the above steps.
10.
Turn Atomizer Valve to OFF position. Turn Vehicle off, turn fuel pump off on the
machine then disconnect fuel hoses, adapters and re attach the EGR temperature
sensor, reconnect fuel lines and reattach the induction tube.
DFS 910-1
DFS 910-5
DFS 910-2
DFS 910-3
DFS 910-5
