-
To set the program
B
press “Timer button
B
” and follow the same procedure as
described for the program
A
.
-
Use the “
+
” or “
-
” buttons to set the desired comfort temperature, as
described above.
-
When set in this way the heater will automatically switch on at the set time for the
designated time period and automatically maintain the preset comfort temperature.
To cancel a preset program, press the timer button
A
or
B
once and then press the
hour button until the display shows “--:--“ (fig.6).
TIMER OVERRIDE
To operate the appliance without using the programs (timer), press the “ON MODE”
button (Fig.5). The yellow lamp will go off.
IMPORTANT:
If the heater looses its electricity supply for more than 2 minutes the appliance does
not switch on. The display shows the blinking numbers.
To switch it on, repeat the above described operations.
WARNINGS
You must leave the heater plugged into the outlet to keep the timer
memory programmed.
If the heater loses its power supply for more than 2 minutes, (e.g. switched off at the
outlet or in the event of a power failure), the heater’s programs will be lost, and the
heater will not work until reset.
A safety device
switches the heater off in the event of overheating. To restart the
heater, call the nearest Service Center to change the safety device.
Note:
when the safety device intervenes, the heater doesn’t heat but the display
works.
4. MAINTENANCE AND SERVICE
Always remove the plug from the power outlet and allow the radiator to cool. Wipe
radiator with a soft damp cloth, do not use detergents and abrasives.
Should the radiator not be in use over a certain length of time, wind the cable round
the holder and store it in a dry place.
This appliance has been built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater by yourself: it may
result in fire hazard or electric shock.
Call the nearest Service Center (see attached list of Service Centers) or call customer
support at 1-800-322-3848.
6
AUTO
:
fig. 6
