9
using your cooking food
processor
1 Plug in and press the On/Off switch
)1
on the
right side of the power unit. The unit will beep and
“WELCOME TO kCook” will be displayed.
2 Fit the bowl
(4
to the power unit by aligning the
locating tab to the back of the unit. Press down
lightly to locate. Note: the bowl cannot be located
unless fitted in the correct orientation.
O
To remove the bowl, push both bowl release
buttons
(5
(situated under the bowl handles) at the
same time and lift the bowl.
3 Select one of the following options:
3A
Manual Cooking – refer to manual mode
section.
3B
Pre-set Programmes:
Refer to ‘using the pre-set programmes’ section for
usage information.
Main Meal programme
)7
Sauce programme
)8
Steam programme
)9
Soup programme
):
Stir Fry programme
*1
Dessert programme
*2
Note: When a pre-set programme button is pressed
the bar above the relevant button will light up.
4 Fit the maxblade
a, knife blade
b, stir tool
,
whisk tool
or slow cook bowl plug
-2
to the
bowl.
Bowl tool
Use
maxblade
For chopping ingredients
before cooking and for
pureeing after cooking is
complete.
Knife blade
For making doughs and cake
batters.
Stir tool
For recipes where you want to
stir gently without breaking the
ingredients down.
Whisk tool
For whisking light ingredients
such as egg whites, cream,
mayonnaise and hollandaise
sauce.
5 Add the relevant ingredients to be processed or
cooked.
6 Fit the lid and filler cap. Push the lid down and turn
anti-clockwise until aligned with the cooking bowl
handles.
The appliance will not operate unless
interlocked correctly.
7 Press the cooking bowl Start/Stop button
+1
to
start the cooking process.
8
Pre-set programmes – at the end of each stage and
once cooking has finished the unit will beep and
automatically go into the Keep Warm cycle for 30
minutes. Follow the instructions on the screen to
move to the next stage.
9 To stop the unit at any time, press the Start/Stop
button and then remove the lid. Take care as the
bowl and lid will be hot. To resume cooking, refit
the lid press the Start/Stop button.
O
Manual
mode – at the end of cooking the timer will
countdown to 00:00 and the unit will beep.
Standby
Mode
O
To return the unit to standby mode, press and hold
the Cancel button for 3 seconds.
O
If no selection is made within 30 minutes the unit
will go into standby mode and “WELCOME TO
kCook” will be displayed on the screen. Press any
function to reactivate the unit.
Keep
Warm
Cycle
O
The Keep Warm cycle will stir the ingredients at
62°C.
O
Remove the lid to check on the progress or add
other ingredients and then press the Start/Stop
button to resume cooking.
O
When the timer has counted down to 00:00 at
the end of each programme stage the unit will
automatically go into the keep warm cycle for 30
minutes.
O
The unit will beep every 10 seconds for the first
minute and then every 30 seconds to indicate the
unit is in the Keep Warm cycle and the cooking
cycle has finished.
O
The keep warm cycle will not heat if the
temperature is set to less than 62˚C.
After
cooking
O
Be careful when handling or touching any part
of the appliance when being used in the cooking
mode or after cooking, IN PARTICULAR THE
BOWL AND TOOLS as they will remain HOT long
after the appliance has been switched off.
O
Use the handles to remove and carry the bowl. Use
oven gloves when handling the hot bowl and hot
tools.
O
The underside of the bowl will remain hot long
after the heating has stopped. Use caution when
handling and cleaning.
Summary of Contents for CCL45
