F R O N T P A N E L
(D
VIDEO
O U T P U T
The video output terminal. The terminal has an
output impedance of 75 ohm. It outputs composite
video signals consisting of synchronizing, blanking,
burst, and the various pattern signal components.
Polarity is positive (the synchronizing signal is
negative).
10
® VIDEO L E V E L
Turn-knob
for
varying the video
output
level. This
knob allows the video output level to be varied from
0 - 1.5 V p-p and, when turned all the way to the
left (CAL), a signal of 1 V p-p can be obtained via the
output terminal.
© S Terminal
The Y , C separation output terminal.
1: Y GND
2:
C
GND
3: Y SIGNAL
4: C SIGNAL
@ Y LEVEL
The Y component of the S output can be varied over
a range of + / ~ 20% by manipulation of the corre-
sponding turn-knob. It is calibrated while turned all
the way counterclockwise.
© C LEVEL
The C component of the S output can be varied over
a range of +/~~ 20% by manipulation of the corre-
sponding turn-knob. It is calibrated while turned all
the way counterclockwise.
© SET LEVEL (SET UP)
When this semi-fixed turn-knob is turned clockwise,
the setup level of the video signal can be varied over
a range of 0-10%. If this knob is turned all the way
in the counterclockwise direction (CAL), the black
level is calibrated to 7.5%. [calibrated to 0% for the
CG-932]
~1
2
-3
4-