29
A
U
T
O
A
U
T
O
AUTOMATIC OVEN COOKING
To cook food automatically in the oven,
it is necessary to:
1. Set the length of the cooking time
2. Set the end of the cooking time
3. Set the temperature and the oven
cooking program.
These operations are done in the follow-
ing way:
1. Set the length of the cooking time by
pushing the
button and the
button to advance, or
to go back if
you have passed the desired time (fig.
6.5). The AUTO and the
symbol
will be on.
2. Set the end of the cooking time by
pressing the
button (the cooking
time already added to the clock time
will appear), and the
button (fig.
6.6); if you pass the desired time you
can go back by pushing the
button.
After this setting, the
symbol will go off. If after this setting,
the AUTO flashes on the panel and a
buzzer goes off, it means there was
an error in the programming, that is
the the cooking cycle has been super-
imposed on the clock. In this case,
change the end of cooking time or the
cooking time itself by following the
instructions above.
3. Set the temperature and the cooking
program (see the relevant sections).
Once the oven is programmed it will
switch on automatically at the right time
to stop the cooking at the desired end
time.
During cooking, the
symbol remains
on.
By pushing the
button you can see
the time that remains until the end of
cooking.
The cooking program may be can-
celled at any time by pushing
.
At the end of the cooking time the oven
will turn off automatically, the
symbol
will turn off, AUTO will flash and the buz-
zer will sound, which can be turned off
by pushing any of the buttons.
Turn the switch and temperature knobs
to "OFF" and put the programmer onto
“manual” by pressing the
button.
Attention: A powercut will make the
clock go to zero and will cancel the set
programs.
After a powercut, three zeros will flash
on the panel.
Fig. 6.6
Fig. 6.5
