D40-1132-05
3
DISASSEMBLY FOR REPAIR
Disassembling
(a) Rotate
7
D GEAR by hand until the position shown in fig-
ure where
‘
PACK SLIDER gets stuck to the stopper.
-Position traveling over the PULL.E a little.-
(b) Raising the part shown in figure with a thin edge screw-
driver, push the
‘
PACK SLIDER in arrow direction,
avoiding interference with the stopper.
(c) Disengage the boss from the PS ACTUATOR PLATE,
and the PACK SLIDER will be removed.
(d) Further turning CCW the
|
PS ACTUATOR PLATE,
raise the Guide shown with an arrow while meeting with
the hole in
]
CASE LIFTER, and the PS ACTUATOR
PLATE can be removed.
(e) At the same time, remove
“
PS SPRING from the
]
CASE LEFTER (if necessary), and from the
|
PS
ACTUATOR PLATE.
Reassembling
(a) Rotating
7
D GEAR in the deck until the position where a
marker on OP PLATE Ass'y travels over the pulley a lit-
tle.
(b) Hook
“
PS SPRING to the
|
PS ACTUATOR PLATE
from the bottom. Meeting the hole with the boss of
]
CASE LIFTER, insert a bent portion into a sector hole
in the
]
CASE LIFTER (step (b) in previous item).
(c) Under this condition, insert the
‘
PACK SLIDER so that
its "A" and "B" portions come out under and above the
]
CASE LIFTER respectively.
(d) Insert the boss into
|
PS ACTUATOR PLATE, and slide
toward the front.
(e) Rotate the D GEAR clockwise to set up the EJECT sta-
tus.
(f) Hook another end
“
PS SPRING to the
]
CASE LIFTER.
(a)
(b)
(d)
(b)
(c)
(d)
‘
PACK SLIDER
‘
PACK SLIDER
‘
PACK SLIDER
|
PS ACTUATOR PLATE
|
PS ACTUATOR PLATE
|
PS ACTUATOR PLATE
]
CASE LIFTER
]
CASE LIFTER
“
PS SPRING
B
A
C
1.2.
‘
PACK SLIDER/
|
PS ACTUATOR PLATE
CAUTION:
The PACK SLIDER is damageable during disassembling, and it cannot be reused. and it cannot be reused.
