D40-1132-05
6
DISASSEMBLY FOR REPAIR
1.5.
’
REEL PWB Ass'y/
»
CR DETECTIVE PLATE
Disassembling
(a) Remove four screws as shown in figure.
Remove the REEL PWB Ass'y, can be removed.
Reassembling
(a) Align the marking of the MODE SW on he REEL PWB
Ass'y with a square hole, as shown in fig(a).
(b) IN reassembling, adjust the REEL PWB Ass'y so that the
first tooth of
&
OP PLATE gear enters between two pro-
trusions that can be seen through a window, then adjust
four screw positions.
(c) Tighten four 200 2 X 2.2CAMERA SCREW. (previous
Fig.(a))
1.6.
5
B GEAR/
6
C GEAR/
7
D GEAR
Disassembling
(a) As these Gears are fit forcibly, to remove the Gears.
raise them from the bottom with a flathead screw driver
while taking care not to damage other parts.
(b) As for the disassembling order, first remove
6
C GEAR,
then
5
B GEAR or
7
D GEAR. (Removed parts cannot
be reused.)
Reassembling
(a) Fit the B GEAR forcibly with a small gear side facing up
while meshing with A GEAR ( CM2 SUB MOTOR Ass'y).
(b) Fit the D GEAR forcibly with a small gear side facing
down while meshing a small gear with the gear of
&
OP
PLATE Ass'y.
(c) Fit the C GEAR forcibly with a small gear side facing
down while meshing a small gear with D GEAR and also
a large gear with B GEAR.
In any case after fitting, confirm that the Gears rotate
smoothly.
