Settings
Settings
<Supreme>
*2
Restores the sound lost due to audio compression to a
realistic sound.
•
OFF
/
ON
(Initial)
<Realizer>
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
•
OFF
(Initial)/
Level 1
/
Level 2
/
Level 3
<Stage EQ>
Moves the center of the sound to the lower or higher
point. Select the height.
•
OFF
(Initial)/
Low
/
Middle
/
High
*1 You cannot change the setting when “Radio” or “DAB” (only for
DDX4018DAB) is selected as the source.
*2 This function works only when “DISC”/ “USB”/ “iPod”/
“Android™” is selected as the source.
<Fader/Balance>
Touch
[
J
]
/
[
K
]
/
[
H
]
/
[
I
]
or drag the
mark to adjust.
<Fader>
Adjusts the front and rear speaker output balance.
When using a two-speaker system, set the fader to the
center (
0
).
•
F15
to
R15
(Initial:
0
)
<Balance>
Adjusts the left and right speaker output balance.
•
L15
to
R15
(Initial:
0
)
To clear the adjustment:
Touch
[Center]
.
Setting the speakers and crossover
frequency
1
Select a car type (
1
), select the location
of the speakers (
2
), then display the
<Speaker Select> screen (
3
).
• Speaker location selection is available only when
<X’over Network>
is set to
[2way]
.
2
Select the speaker type (
1
), select the size
of the selected speaker (
2
), then display
the <X’over> screen (
3
).
• If a speaker is not connected, select
<None>
.
• When setting the front speakers, also select the
speaker size for
<Tweeter>
.
<Speaker/X’over>
Before making any settings for the speakers and
crossover frequency, select the appropriate crossover
network mode according to the speaker system (2-way
speaker system or 3-way speaker system).
• Connecting 3-way speakers with 2-way crossover
network mode selected may damage the speakers.
Crossover network mode settings
1
Display the source/option selection screen.
On the Home screen, touch as follows:
2
Put the unit in standby.
On the source/option selection screen, touch as
follows:
3
Press
M
and MENU on the monitor panel
at the same time to display the <X’over
Network> screen.
4
Select the crossover network mode.
[2way]
Select this when connecting speakers
in a 2-way system (front/rear).
[3way]
Select this when connecting speakers
in a 3-way system (tweeter/mid
range/woofer).
A confirmation message appears. Touch
[Yes]
to
confirm.
33
ENGLISH
00_DDX318BT_EN_ENG.indb 33
00_DDX318BT_EN_ENG.indb 33
13/6/2017 9:43:28 AM
13/6/2017 9:43:28 AM
