English
71
Navigation Setup
You can set Navigation parameters.
Display the Navigation Setup screen
1
Touch [
]
>
[
]
>
[Navigation]. (page 58)
Set each item
2
[NAV Interrupt Speaker]
Selects speakers
used for voice guidance of the navigation
system.
(
"Front All")
"Front L": Uses the front left side speaker for
voice guidance.
"Front R": Uses the front right side speaker for
voice guidance.
"Front All": Uses both front speakers for voice
guidance.
[NAV Voice Volume]
Adjusts the volume for
voice guidance of the navigation system.
(
DNX models: "25", DDX models: "21")
[Line Mute]
Mutes the volume during voice
guidance of the navigation system.
(
"ON")
When turned "ON", the volume level drops for
voice guidance.
[Navigation Input]
Selects a navigation
system connection. (
"RGB") (DDX models
only)
"RGB": Allows the Kenwood’s Navigation
System to connect via its interface
cable.
"AV-IN": Allows a third-party navigation system
to connect via the AV INPUT1 port.
"OFF": Must be used if no navigation system
is connected. (The navigation display
is cancelled when the AV source is
switched.)
[On Screen Navigation]
Sets an on-screen
display of the navigation screen. (
"OFF")
(DDX models only)
"Auto": Information is displayed for 5 seconds
when updated.
"OFF": Information is not displayed.
DSP Bypass Control (DNX/DDX7 models)
Temporarily bypassing DSP (Digital Signal
Processor) System.
Display the Audio SETUP screen
1
Touch [
]
>
[
]
>
[Audio SETUP]. (page
58)
Set the DSP Select
2
[Bypass]
There is no effect by DSP.
[Through]
There is an effect by DSP.
⁄
When the mode is set to [Bypass], DSP System cannot
•
be adjusted.
B64-4512-00̲01-M̲English.indd 71
B64-4512-00̲01-M̲English.indd 71
09.4.20 9:18:37 AM
09.4.20 9:18:37 AM