DMF-5020/DMF-3020/MD-203 (En)
29
1
Go to step
2
if setting adjustments are not required.
2
3
1
Switch the REC MODE on.
2
Select the setting adjustment mode.
3
Set the selection.
Adjust the settings if required.
Recording (DIGITAL input)
Recording is possible using recordable Mini Discs. When this unit is connected with a component equipped with digital output,
such as a CD player, through a digital cord or optical fiber cable, the signal input through the DIGITAL input jack can be recorded
in the digital format (this recording is referred to as digital recording). Enjoy high-quality sound of digital recording!
Preparation
1
Open the write protect tab of the Mini Disc to make it recordable.
8
2
Load the Mini Disc.
3
Check the remaining recording time.
o
4
Set the amplifier’s input selector to the source to be recorded.
Select AUTO or MANUAL. (Remotecontrol unit only)
Select one of “DIGITAL 1, 2 ”.
Each press switches the mode.
1
REC MODE :
off
2
REC MODE :
on
Each press switches the mode.
1
ANALOG
:
Analog “stereo mode”
2
DIGITAL 1 :
Optical input mode
3
DIGITAL 2 :
Coaxial input mode
4
MONO
:
Analog “monaural long-play mode”
Each press switches the mode.
1
goes off
(AUTO) :
Track numbers are marked automatically.
¢
2
MANUAL
:
Track numbers can be marked as desired.
¢
÷
For details on the setting adjustment modes, see
“REC MODE key”
.
¢
DIGITAL recording
REC MODE/CHARAC.
4
¢
JOG DIAL
4
¢
SET
REC INPUT
AUTO/MANU.
The modes are switched by rotating the JOG DIAL.
AUTO CUT?
:
AUTO CUT on/off selection.
AUTO TIME?
:
Setting of the time for detecting a no-sound
blank section during automatic track number
marking.
AUTO LEVEL?
:
Automatic track number marking no-sound
blank detection level and SOUND SYNCHRO
REC, AUTO CUT and REC AUTO PAUSE sound
detection level setting.
REC
=
WRITING? :
Setting of the UTOC writing after recording.
