122
123
Ñ
DSP select
You can select whether using DSP (Digital
Signal Processor) System.
1
Touch [Bypass] or [Through] of [DSP
Select] in the Audio SETUP screen.
Bypass
There is no effect by DSP.
Through
There is an effect by DSP.
NOTE
• When the mode is set to [Bypass], DSP System
cannot be adjusted.
Controlling General Audio
1
Touch [Audio Control].
2
Set each item as follows.
Fader # / Balance #
Adjust the volume balance around the
touched area.
[
C
] and [
D
] adjust the right and left volume
balance.
[
R
] and [
S
] adjust the front and rear volume
balance.
Volume Offset*
Finely adjust the volume of the current source
to minimize the difference in volume between
different sources.
Subwoofer Level
Adjust the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See
Bass Boost
Set the amount of bass boost among “OFF”/
“Level1”/ “Level2”/ “Level3”.
* If you have increased the volume first, then
reduced the volume using the “Volume
Offset”, the sound generated if you
suddenly switch to another source may be
extremely loud.
Equalizer Control
You can adjust equalizer by selecting the
optimized setting for each category.
1
Touch [Equalizer].
Equalizer screen appears.
Controlling EQ curves
1
Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
[Powerful], [iPod], and [User].
NOTE
• [iPod] is available only during iPod source.
Controlling equalizer manually
The Graphic Equalizer cannot be set when
you select [iPod] in the Equalizer screen.
1
Touch [EQ] in the Equalizer screen.
2
Touch the screen and set the Graphic
Equalizer as desired.
Gain level (light green boxed area)
Adjust the gain level by touching the each
frequency bar.
Touching [
C
], [
D
], [
R
] and [
S
] can also
adjust the level. Use [
C
] and [
D
] to select a
frequency, and [
R
] and [
S
] to set the level.
EQ INIT
Returns to the previous level which the gain
level is adjusted.
Flat
Tone curve becomes flat.
Bass EXT (Bass Extend Settings)
When turned on, the frequency lower than
62.5 Hz is set to the same gain level as 62.5 Hz.
Loudness
Set the amounts of boost of low and high
tones. “OFF”, “Low”, “High”
SW Level
Adjust the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See
.
Summary of Contents for DNN9330BT
Page 76: ......
