2
P
re
p
a
ra
ti
o
n
s
DV-502/DVF-3050 (EN/K,P,T,M ,Y)
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REM OVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SER-
VICING TO QUALIFIED SERVICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYM BOL, WITHIN AN EQUILATERAL TRI-
ANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DAN-
GEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE THAT M AY BE OF SUFFICIENT
M AGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAM ATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT
THE USER TO THE PRESENCE OF IM PORTANT OPERATING AND M AINTENANCE (SER-
VICING) INSTRUCTIONS IN THE LITERATURE ACCOM PANYING THE APPLIANCE.
Units are designed for operation as follow s.
Safety precautions
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use
only a 3-Amp ASTA-approved (BS 1362) fuse.
2. The fuse cover must be refitted w hen replacing the
fuse in the moulded plug.
3. Do not cut off the mains plug from this equipment. If
the plug fitted is not suitable for the pow er points in
your home or the cable is too short to reach.
A pow er point, then obtain an appropriate safety
approved extension lead or adapter, or consult your
dealer. If nonetheless the mains plug is cut off,
remove the fuse and dispose of the plug immediately,
to avoid a possible shock hazard by inadvertent.
Connection to the mains supply.
IM PORTANT :
The w ires in the mains lead are coloured in accordance
w ith the follow ing code:
Blue
: Neutral
Brow n : Live
Do not connect those leads to the earth terminal of a
three-pin plug.
For the United Kingdom
WA RN IN G :TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR M OISTURE.
The marking is located on the rear panel and says that
the component uses laser beams that have been clas-
sified as Class 1. It means that the unit is utilizing laser
beams that are of a w eaker class. There is no danger of
hazardous radiation outside the unit.
CLASS 1
LASER PRODUCT
The marking of products using lasers
(Except for some areas)
U.S.A. and Canada ....................................................... AC 120V only
Australia ....................................................................... AC 240 V only
Before applying pow er
Caution : Read this page carefully to ensure safe operation.
Introduction
Caution : Read this page carefully to ensure safe operation.
CAUTION
R I S K O F E L E C T R I C S H O C K
D O N O T O P E N
Europe and U.K. ............................................................ AC 230V only
* Other countries .................... AC 110-120 / 220-240 V sw itchable
http://www.usersmanualguide.com/
