before using your Kenwood
appliance
●
Read these instructions carefully and
retain for future reference.
●
Remove all packaging and any
labels.
safety
●
Do not operate the appliance
without the lid fitted.
●
Avoid contact with moving parts.
Keep hands, hair, clothing, spatulas
and other utensils away during
operation to reduce the risk of injury
to persons and/or damage to the
appliance.
●
Keep hands and utensils out of the
slushie container when it’s on the
power unit.
●
When removing the slushie container
from the power unit, wait until the
ice paddle and slushie paddle have
completely stopped.
●
Switch off and unplug:
●
●
before fitting and removing
parts
●
●
after use
●
●
before cleaning.
●
Do not exceed the MAX capacity
(1 litre).
●
Do not immerse the appliance, cord
or plug in water or any other liquid.
●
Do not let the cord hang over the
edge of the worksurface or touch
hot surfaces.
●
Never use a damaged appliance.
Get it checked or repaired: see
‘service’.
●
Never use an unauthorised
attachment.
●
Never leave the appliance on
unattended.
●
To prevent freezer burn, always
ensure that hands are fully protected
when handling ice.
●
Do not use outdoors.
●
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
●
Children should be supervised to
ensure that they do not play with the
appliance.
●
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before plugging in
●
Make sure your electricity supply is
the same as the one shown on the
underside of the machine.
●
This machine complies with
European Economic Community
Directive 89/336/EEC.
Important – UK only
●
The wires in the cord are coloured
as follows:
Blue = Neutral, Brown = Live.
●
The appliance must be protected by
a 3A approved (BS1362) fuse.
Note:
●
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable pug is inadvertently
inserted into a 13A socket outlet.
2
a
b
