46
English
Timer Operation (continued)
4
The same operation is also available on the main unit.
* When the system is switched to the standby mode
while a timer program is activated, message
[SETUP TIMER] is displayed and the standby/timer
indicator lights in amber.
* Be sure to set the power switch to ON before
pressing this key.
Each press of the key switches the timer
programs as shown below.
Set the power switch to OFF.
If any of the operations of “Moving Music from Memory Card to USB Audio Player” (pages
30 and 31), “Erasing Music” (pages 36 and 37) and “Erasing All Data in Memory Card” (page
67) is performed while a timer program is being executed, the system is not switched OFF
even after the timer end time.
* Later, if the power cord is unplugged then
plugged in or after a power failure, message
[CHECK CLOCK] is displayed and the standby/
timer indicator blinks in amber. In this case, set the
correct system time again.
To check or modify a timer program or to correct it after making a mistake, restart the
setup procedure from the beginning.
Even the system is used for playback, etc. after activating a timer program, the timer
program is not affected.
PROGRAM 1 is in
ON state.
PROGRAM 2 is in
ON state.
PROGRAM 1 and 2
is in ON state.
Both timer
programs are
in OFF state.
To cancel (switch OFF) or reactivate (switch ON) the timer programs:
Hint
ON
ON
ON
OFF
Summary of Contents for K-501USB
Page 76: ...76 English ...
