11
installation
levelling the washer dryer
There are levelling feet on the underside. They must be adjusted to make sure the machine is
level.
1. On each foot, loosen the lock ring by turning it
clockwise.
2. Adjust all feet by rotating each upwards or
downwards.
3. Use a spirit level to ensure the machine is level.
4. Tighten each lock ring by turning them anti-
clockwise (towards the machine body).
Ensure all lock rings are tightened securely. Check
that the feet are still bolted to the machine - if they’re
unbolted, the machine will move around.
water supply hose
Points to remember
• Follow the instructions in this section to avoid water leaks.
• Don’t connect the hose to a combination tap.
• Don’t twist, squash, modify or cut the hose.
• This machine is designed to connect to the cold water supply. Do not connect to the hot
water supply.
• Use only the new water supply hose supplied. Old hose sets should not be reused.
hose and cable lengths
How to connect from the left side
How to connect from the right side
~80cm
~90cm
110 -135cm
min. 60cm
max. 100cm
~40cm
~130cm
K10W7D18_IB_180412_grace.indd 11
12/4/18 4:01 pm