(No.WA001<Rev.001>)12/18
z
Mode structure
Some Test Modes change according to the current source.
The following table shows the current source in Set and the related test mode status.
z
Mode content
Syscom shall display the following information after entering this mode. The operation shown below shall be workable.
z
STANDBY Test Mode Specification
Various setting value
Volume
30 (-10dB)
BASS BOOST
OFF
EQ
NATURAL
Fader/Balance
Center
DEMO Mode Setting
OFF
AUX Setting
ON
NAVI MUTE Setting for Japan
Detecting function valid (ATT)
Model source
Test mode
POWER OFF
-
Standby
STANDBY Test Mode
TUNER
UNER Test Mode
CD
CD Test Mode
AUX
-
Display content
Details
The display is released when another operation is executed.
The display will blink if sub clock is not functioning.
P
R
O
T
T
E
S
Operation
Display content
Details
1 (Toggle)
Syscom version
display
Syscom version (Refer to Syscom Version Table)
All lights ON
All lights ON (Switch with other display)
2 (Toggle)
Serial No. display
Serial No. display (8-digit)
∗
Display as it is in hex
All lights ON
All lights ON (Switch with other display)
3 (Toggle)
All lights ON/OFF
All lights ON/OFF with toggle
5 (Toggle)
Preout switch
Switch Preout with toggle
6
FL display short
check
All lights ON
→
All lights OFF
→
odd terminal and
even terminal of the largest grid ON alternatively
every 125ms
→
odd terminal ON
→
even terminal
ON
→
(repeat continuously)
SOURCE
transition
Mode release
Return to Normal mode
RETURN
(Toggle)
All lights ON/OFF
All lights ON/OFF with toggle
Y
–
S
S
S
N
0
0
0
0
0
0
0
0
S
W
P
R
R
R
E
E
A
S
W
P
R
S
–
E
U
B
W
