73
|
KDC-BT92SD
English
|
74
Connecting Wires to Terminals
Connector Function Guide
Pin Numbers for
ISO Connectors
Cable Colour
Functions
External Power
Connector
A-4
Yellow
Battery
A-5
Blue/White
Power Control
A-6
Orange/White
Dimmer
A-7
Red
Ignition (ACC)
A-8
Black
Earth (Ground)
Connection
Speaker
Connector
B-1
Purple
Rear Right (+)
B-2
Purple/Black
Rear Right (–)
B-3
Gray
Front Right (+)
B-4
Gray/Black
Front Right (–)
B-5
White
Front Left (+)
B-6
White/Black
Front Left (–)
B-7
Green
Rear Left (+)
B-8
Green/Black
Rear Left (–)
2
WARNING
Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on
the type of vehicle you drive. Make sure to make the proper
connections to prevent damage to the unit.
The default connection for the wiring harness is described in
1
below. If the ISO connector pins are set as described in
2
,
make the connection as illustrated.
Please be sure to reconnect the cable as shown
2
below to
install this unit to the
Volkswagen
vehicles etc.
1
(Default setting) The A-7 pin (red) of the vehicle’s
ISO connector is linked with the ignition, and
the A-4 pin (yellow) is connected to the constant
power supply.
Unit
Vehicle
A-7 Pin (Red)
A-4 Pin (Yellow)
Ignition cable (Red)
Battery cable (Yellow)
2
The A-7 pin (red) of the vehicle’s ISO connector is
connected to the constant power supply, and the
A-4 pin (yellow) is linked to the ignition.
Unit
Vehicle
A-7 Pin (Red)
A-4 Pin (Yellow)
Ignition cable
(Red)
Battery cable
(Yellow)
Installation/Removing the Unit
Installation
Bend the tabs of the mounting
sleeve with a screwdriver or similar
utensil and attach it in place.
⁄
• Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
¤
CAUTION
Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and
shortly after the use of the unit. Metal part such as
the heat sink and enclosure become hot.
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Catch
Lock
Accessory
2
Removal tool
2
When the upper level is removed, remove the
lower two locations.
⁄
• The frame can be removed from the bottom side in the
same manner.
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Detach the faceplate.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
4
Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
Accessory
2
¤
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands, being
careful not to drop it.
