11
installation
• Do not bend your drain hose.
6. Position the dishwasher next to a water tap
and a drain. Ensure the water inlet and drain
hoses are not kinked or squashed. The unit
must not stand on the mains cable.
7. Make sure your plumbing is suitable for
use with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using
the new water inlet hose. OLD HOSE SETS
MUST NOT BE RE-USED. The water
pressure from the water mains needs to be at
a minimum of 0.04 MPa and a maximum of
1.00 MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and then
connect the other end of the hose to your
water mains. Please ensure the black
rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
water mains
Y-Adaptor
(not included)
safety water supply hose
Connect
to another
appliance
if required.
You may use a Y-adaptor (not
included) for an additional water
feed for another appliance, for
example a washing machine. This
is only applicable for cold water
mains. A Y-adaptor is available
from most DIY stores.
KDW45X15_IB_RC_151229_grace.indd 11
29/12/15 3:54 pm