p
pr
ro
ob
blle
em
m
●
The whisk or K-beater knocks against the bottom of the bowl or isn’t
reaching the ingredients in the bottom of the bowl.
solution
●
Adjust the height using the spanner provided. Here’s how:
1
Unplug the appliance.
2
Raise the mixer head and insert the whisk or beater.
3
Lower the mixer head. If the clearance needs to be adjusted, raise the
mixer head and remove the tool. Ideally the whisk and K-beater should be
almost
touching the bottom of the bowl
.
4 Using the spanner provided loosen the nut
sufficiently to allow
adjustment of the shaft
. To lower the tool closer to the bottom of the
bowl, turn the shaft anti-clockwise. To raise the tool away from the bottom
of the bowl turn the shaft clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary until the tool is set correctly. Once
this is acheived tighten the nut securely.
problem
●
The mixer stops during operation.
solution
●
Your mixer is fitted with an overload protection device and will stop if
overloaded to protect the machine. If this happens, unplug the mixer.
Remove some of the ingredients to reduce the load, and allow the
mixer to stand for a few minutes. Plug in and press the start/stop
button. If the mixer does not restart immediately allow to stand for
additional time.
●
If for any reason power to the mixer is interrupted and the machine stops
working, switch off by pressing the start/stop button, wait a few seconds
and then switch on again. The mixer should resume operating straight
away.
to fit and use your splashguard
1
Raise the mixer head until it locks.
2
Fit the bowl onto the base.
3
Push the splashguard onto the underside of the mixer head
until fully
located. The hinged section should be positioned as shown.
4
Insert required tool.
5
Lower the mixer head.
●
During mixing, ingredients can be added directly to the bowl via the
hinged section of the splashguard
.
●
You do not need to remove the splashguard to change tools.
troubleshooting
9
min
1
2
3
4
P
min
sec
m
in
1
2
3
4
5
6
P
m
in
se
c
Summary of Contents for KMC030series
Page 118: ......
