15
ENGLISH |
Data Size:
B6L (182 mm x 128 mm)
Book Size:
B6L (182 mm x 128 mm)
Symptom
Remedy
“iPod ERROR” appears.
Reconnect the iPod. / Reset the iPod.
“READING” keeps flashing.
Do not use too many hierarchical levels or folders.
Elapsed playing time is not
correct.
This is caused by how the tracks are recorded.
Correct characters are not
displayed (e.g. album name).
This unit can only display uppercase letters, numbers,
and a limited number of symbols. Uppercase Cyrillic
letters can also be displayed if
[RUSSIAN SET]
is set to
[РУССКИЙ BКЛ]
.
( 4)
Bluetooth®
No Bluetooth device
is detected.
• Search from the Bluetooth device again.
• Reset the unit.
( 3)
Pairing cannot be
made.
• Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again.
( 8)
“DEVICE
FULL”
appears.
The number of registered devices has reached its limit.
Retry after deleting an unnecessary device.
( 11,
DEVICE DELETE)
Echo or noise occurs.
• Adjust the microphone unit’s position.
( 8)
• Check the
[ECHO CANCEL]
setting.
( 9)
Phone sound quality
is poor.
• Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
• Voice calling method
is not successful.
• “N/A VOICE TAG”
appears.
• Use voice calling method in a more quiet environment.
• Reduce the distance from the microphone when you
speak the name.
• Make sure the same voice as the registered voice tag is
used.
TROUBLESHOOTING
Symptom
Remedy
Bluetooth®
“NOT
SUPPORT”
appears.
The connected phone does not support Voice
Recognition feature.
• “NO ENTRY” appears.
• “NO PAIR” appears.
There is no registered device connected/found via
Bluetooth.
“ERROR” appears.
Try the operation again. If “ERROR” appears again,
check if the device supports the function you have
tried.
“NO INFO” appears.
Bluetooth device cannot get the contact information.
Sound is being
interrupted or skipped
during playback of a
Bluetooth audio player.
• Reduce the distance between the unit and the
Bluetooth audio player.
• Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to
the unit.
The
connected
Bluetooth audio player
cannot be controlled.
• Check whether the connected Bluetooth audio player
supports Audio/Video Remote Control Profile (AVRCP).
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
• “HF ERROR XX”
appears.
• “BT ERROR” appears.
Reset the unit and try the operation again. If this does
not solve the problem, consult your nearest service
center.
JS_KWD_KMM_BT34_EN_001B_EN.indd 15
JS_KWD_KMM_BT34_EN_001B_EN.indd 15
16/12/2013 2:12:30 PM
16/12/2013 2:12:30 PM
