7
K-beater & Whisk
The tools are set to the correct height for
the bowl supplied in the factory and should
not require adjustment.
However, if you wish to adjust the tool use
the spanner provided.
Then follow the instructions below:
1 Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the clearance
needs to be adjusted, raise the mixer
head and remove the tool. Ideally the
whisk and K-beater should be
almost
touching the bottom of the bowl
6
.
4 Using the spanner provided loosen the
nut sufficiently to allow adjustment of the
shaft
7
. To lower the tool closer to the
bottom of the bowl, turn the shaft anti-
clockwise. To raise the tool away from
the bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the
mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once this is
achieved tighten the nut securely.
• Always switch off and unplug before
cleaning.
• A little grease may appear at the slow
speed outlet
2
when you first use it.
This is normal – just wipe it off.
Power Unit, Outlet Covers and Finger
Guard
• Wipe with a damp cloth, then dry.
• Never use abrasives or immerse in water.
Bowl
• Wash by hand, then dry thoroughly or
wash in the dishwasher.
• Never use a wire brush, steel wool or
bleach to clean your stainless steel bowl.
Use vinegar to remove limescale.
• Keep away from heat (cooker tops,
ovens, microwaves).
Tools
• Wash by hand, then dry thoroughly or
wash in the dishwasher.
recipe
chilli marinade
300g cold clear runny honey (refrigerated
overnight)
1 chilli (whole)
20g (1tsp) crunchy peanut butter
Seasoning
1 Place all the ingredients into the mini
chopper/mill.
2 Fit the attachment to the Kitchen
Machine and allow the ingredients to
settle around the blade.
3 Switch to pulse
P
P
for 4 seconds.
4 Use as required.
Tool Adjustment
Care & Cleaning
