8
EN
Setting up the system
Make connections as shown in the following pages.
When connecting the related system components, be
sure to refer to the instruction manuals supplied with
the components you are connecting.
Do not connect the power cord to a wall outlet until all
connections are completed.
Notes
1. Be sure to insert all connection cords securely. If their connections are
imperfect, the sound may not be produced or there will be noise
interference.
2. Be sure to remove the power cord from the AC outlet before plugging
or unplugging any connection cords. Plugging/unplugging connection
cords without disconnecting the power cord can cause malfunctions
and may damage the unit.
3. Do not connect power cords from components whose power
consumption is larger than what is indicated on the AC outlet at the
rear of this unit.
Analog connections
Audio connections are made using RCA pin cords. These cables transfer
stereo audio signal in an “analog” form. This means the audio signal
corresponds to the actual audio of two channels. These cables usually
have 2 plugs at each end, red for the right channel and white for the left
channel. These cables are usually packed together with the source unit,
or are available at your local electronics retailer.
Input mode settings
“
CD
/
DVD
”
,
“
VIDEO2
”
and “
DVD/6CH
” inputs each include jacks
for digital audio input and analog audio input.
After completing connections and turning on this model, follow the
steps below.
1
Use the INPUT SELECTOR knob to select “CD/DVD”,
“VIDEO2”, “DVD/6CH”.
2
Press the INPUT MODE key.
Each press switches the setting as follows:
In DTS play mode
1
F-AUTO
(digital input, analog input)
2
D-MANUAL
(digital input)
In CD/DVD, VIDEO2, DVD/6CH play mode
1
F-AUTO
(digital input, analog input)
2
D-MANUAL
(digital input)
3
6CH INPT
(DVD/6CH input)
*
4
ANALOG
(analog input)
*
“6CH INPT” setting can be switched only when the input
selector is set to “DVD/6CH”.
Digital input:
Select this setting to play digital signals from a DVD, CD, or LD
player.
Analog input:
Select this setting to play analog signals from a cassette deck, VCR,
or record player.
Auto detect:
In “
F-AUTO
” (full auto) mode (
AUTO DETECT
and
DIGITAL
indicators light up), this model detects the digital or analog input
signals automatically. Priority is given to digital signal during input
mode selection. This model will select the input mode and listening
mode automatically during playback to match the type of input
signal (Dolby Digital, PCM, DTS ) and the speaker setting. The initial
factory setting is full auto.
To keep this model set to the currently selected listening mode, use
the
INPUT MODE
key to select “
D-MANUAL
” (digital manual).
However, even when this setting is selected, there may be cases
in which the listening mode is selected automatically to match a
Dolby Digital source signal depending on the combination of listening
mode and source digital.
In
D-MANUAL
mode, if the audio reproduction stops in the middle
due to change in the input signals etc, press the
LISTEN MODE
key.
If the
INPUT MODE
key is pressed quickly, sound may not be
produced. Press the
INPUT MODE
key again.
LISTEN MODE
INPUT SELECTOR
INPUT MODE
Microcomputer malfunction
If operation is not possible or an erroneous display appears, even
though all connections have been made properly, reset the
microcomputer by referring to “In case of difficulty”.
‹
CAUTION
Install the equipment so that the power outlet is easily accessible
and, in case of emergency, immediately unplug the power cord from
the power outlet.
The power in this equipment will not be completely cut off from the
AC wall outlet when the main switch is turned OFF.
5632_08_15_EN
06.4.20, 2:00 PM
8
