2
KVT-514/524DVD/534DVD
/534DVDM/54DVDR/554DVD
CAUTIONS IN ASSEMBLING PANEL DRIVE MECHANISM (A10-5171)
Observe the instructions described in this document when
you are going to replace the parts or components that are
shown in this document.
1. Replacement of motor
fl
at spring
• When mounting the flat spring that shall be in contact
with the worm gear, press the spring toward the direction
shown with an arrow so that there will be no gap be-
tween the tip of the gear and the spring and then mount
the spring. The gear shall be pressure-inserted into the
motor.
• Note that there are two motors. Above operation of
mounting the
fl
at spring is required on both of them.
Tilt drive gear train
Slide drive gear train
Mount the flat spring
while pressing it
towards the direction
shown with an arrow
so that there will be no
clearance.
Mount the flat spring
while pressing it
towards the direction
shown with an arrow
so that there will be no
clearance.
DC Motor
Worm
Flat Spring
DC Motor
Worm
Flat Spring