8
SCAN
Scan monitors for signals on the transceiver channels. While scanning, the transceiver
checks for a signal on each channel and only stops if a signal is present.
To begin scanning, press the key programmed as
[Scan]
.
• The indicator appears.
•
When a signal is detected on a channel, Scan pauses at that channel. The transceiver
will remain on the busy channel until the signal is no longer present, at which time Scan
resumes.
To stop scanning, press the
[Scan]
key again.
Note:
To use Scan, there must be at least 2 channels in the scan sequence.
TEMPORARY CHANNEL LOCKOUT
During scan, you can temporarily remove specifi c channels from the scanning sequence by
selecting them and pressing the key programmed as
[Scan Delete/Add]
.
•
The channel is no longer scanned. However, when scanning is ended and restarted,
the channels are reset and deleted channels will again be in the scanning sequence.
PRIORITY SCAN
If a Priority channel has been programmed, the transceiver will automatically change to the
Priority channel when a call is received on that channel, even if a call is being received on
a normal channel.
• The
indicator appears when the selected channel is the Priority channel (depending
on dealer setting).
SCAN REVERT
The Scan Revert channel is the channel selected when you press the
PTT
switch to
transmit during scan. Your dealer can program one of the following types of Scan Revert
channels:
•
Selected:
The last channel selected before scan.
•
Se Talkback:
Same as “Selected”, plus you can respond to calls on the
channel at which scan is paused.
•
Priority:
The Priority channel.
•
Pr Talkback:
Same as “Priority”, plus you can respond to calls on the channel
at which scan is paused.
•
Last Selected:
The last channel on which you receive a call.
