10
FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION
FleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned by
JVC KENWOOD Corporation.
Note:
This function is available only in analog operation.
SELCALL (SELECTIVE CALLING)
A Selcall is a voice call to a station or group of stations.
■
Transmitting
1
Select your desired zone and channel.
2
Press the key programmed as
[Selcall]
to enter Selcall mode.
3
Press
the / key to select the station you want to call.
4
Press
the
PTT
switch and begin your conversation.
■
Receiving
An alert tone will sound and the transceiver will enter Selcall mode. The calling station’s
ID will appear when a Selcall is received. You can respond to the call by pressing the
PTT
switch and speaking into the microphone.
■
Identifi cation Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number. Each
transceiver has its own ID.
•
Enter a Fleet number (100 ~ 349) to make a group call.
•
Enter an ID number (1000 ~ 4999) to make an individual call in your fl eet.
•
Enter a Fleet number to make a call to all units in the selected fl eet (Fleet call).
STATUS MESSAGE
You can send and receive 2-digit Status messages which may be decided in your talk
group. Messages can contain up to 16 alphanumeric characters. Status messages range
from 10 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages (combined status messages and short messages)
can be stored in the stack memory of your transceiver.
■
Transmitting
1
Select your desired zone and channel.
2
Press the key programmed as
[Status]
to enter Status mode (proceed to step 5) or
[S Status]
to enter Selcall mode (proceed to step 3).
3
Press
the / key to select the station you want to call.
•
If Manual Dialing is enabled, you can enter a station ID by using the microphone
DTMF keypad by pressing and holding the
S
or key. Repeat this process
until the entire ID is entered.
4
Press
the
S
or key to enter Status mode.
