18
•
Select “ALL” Fleet and “ALL” ID to make a call to all units
(Broadcast call).
6
7$786
0
(66$*(
You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to 16
alphanumeric characters. Status messages range from 10 to
99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages (combined status
messages and short messages) can be stored in the stack
memory of your transceiver.
Q
7UDQVPLWWLQJ
1
Select your desired zone and channel.
2
Press the key programmed as
Status
to enter Status
mode (proceed to step 5) or
S Status
to enter
Selcall mode (proceed to step 3).
3
Press
/
to select the station you want to call.
•
If Manual Dialing is enabled, you can enter a station ID by
using the DTMF keypad, or by using
/
. When using
/
, cycle through the digits to select a digit, then
press
to set the digit and move the cursor to the right.
Repeat this process until the entire ID is entered.
4
Press
to enter Status mode.
5
Press
/
to select the status you want to transmit.
•
If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using
/
(refer to step
3, above).
6
Press the
PTT
switch or
Side 2
key to initiate the call.
•
“<COMPLETE>” appears on the display when the status
has been successfully transmitted.
Summary of Contents for Nexedge
Page 44: ......