1-8 (No.RA033<Rev.001>)
2.4.3 How to Attach the Supplied Accessories
(1) Attach the front glass to the front panel with the supplied
screw. <1>
(2) To attach the handles on the both sides of the chassis, re-
fer to illustration. <2>
Fig.3
2.5
MODIFICATION
2.5.1 Changing the AUX Port Configuration
The AUX Output Port (pins 10, 11, 13, 14, and 15) on the 15-pin connector (TEST/SPKR) is an open collector connection type as
default, and this port can absorb a maximum of 200 mA.
The AUX Output Port can be used as the output port for High (5 V pull-up resistor output) and Low by changing the configuration of
these pins.
Follow the procedure shown below to change the configuration.
(1) Remove the Control board.
(2) Remove the part from D340,D344, D350, D352, and D354 on the Control board.
(3) Mount the part (part number: DA204U) on D342, D343, D346, D347 and D348 of the Control board respectively.
(4) Mount the resistor (part number: RK73GB2A473J) on R344, R345, R346, R347 and R349 of the Control board respectively.
Front glass
Handle
Handle
<2>
<2>
<1>
Signal
name
Connector
Pin Number
Installing
DA204U
Removing
DA2J101
Installing
RK73GB2A473J
AO1
10
D348
D340
R349
AO2
11
D347
D344
R347
AO3
13
D346
D350
R346
AO4
14
D343
D352
R345
AO5
15
D342
D354
R344
R345
D343
D346
D348
D342
D347
R346
R349
R344
R347
Summary of Contents for NXR-5700
Page 121: ...MEMO ...